(2)
Put warning notices in the cockpit to tell persons not to operate the flaps or slats.
(3)
Put the safety barriers in position.
(4)
Put the access platform in position below the wing fuel tank, zone 540 (640).
4. Procedure
_________
(Ref. Fig. 619/TASK 57-21-00-991-021) Subtask 57-21-00-110-068
A. Preparation for Inspection
WARNING : USE SOLVENTS/CLEANING AGENTS, SEALANTS AND OTHER SPECIAL
_______ MATERIALS ONLY WITH A GOOD SUPPLY OF AIR. OBEY THE MANUFACTURERS INSTRUCTIONS. PUT ON PROTECTIVE CLOTHING. DO NOT GET THEM IN YOUR MOUTH. DO NOT SMOKE. DO NOT BREATHE THE GAS. THESE MATERIALS ARE POISONOUS, FLAMMABLE AND SKIN IRRITANT. GET MEDICAL HELP IF YOUR SKIN OR EYES BECOME IRRITATED.
1EFF : ALL 1 57-21-00Page A605 1 1 Nov 01/04R 1 1 1CES 1
Detail of the Bottom Skin Run Outs Figure 619/TASK 57-21-00-991-021
1EFF : 1 1R 1CES ALL 1 11 1 57-21-00 Page A606 Nov 01/04
(1) Use a clean MISCELLANEOUS (Material No. 19-003), made moist with CLEANING AGENTS (Material No. 11-004) to clean the bottom skin lower surface at the run out of the:
-
stringer 4 (rib bay 10-11)
-
stringer 5 (rib bay 13-14)
-
stringer 13 (rib bay 8-9)
-
stringer 6 (rib bay 16-17)
-
stringer 7 (rib bay 19-20)
-
stringer 12 (rib bay 17-18).
Subtask 57-21-00-210-073
B. Inspection
(1) Examine the lower surface of the bottom skin at the run out of:
-
the stringer 4 (rib bay 10-11)
-
the stringer 5 (rib bay 13-14)
-
the stringer 13 (rib bay 8-9)
-
the stringer 6 (rib bay 16-17)
-
the stringer 7 (rib bay 19-20)
-
the stringer 12 (rib bay 17-18).
Make sure that:
-
there is no corrosion or damage
-
there are no scratches or scores
-
there are no loose or damaged fasteners
-the surface protection is in the correct condition.
NOTE : If necessary, refer to the ASRM (Ref. ASRM 572100) for the
____
correct repair procedure.
5. Close-up
________
Subtask 57-21-00-942-068
A. Removal of Equipment
(1)
Remove the access platform(s).
(2)
Remove the TOOL-ZERO LOCKING, FLAP SLAT CTL LEVER (98D27803500001) from the flap/slat control lever.
(3)
Remove the warning notice(s).
(4)
Remove the safety barriers.
(5)
Remove the ground support and maintenance equipment, the special and standard tools and all other items.
1EFF : ALL 1 57-21-00Page A607 1 1 Nov 01/04R 1 1 1CES 1
TASK 57-21-00-200-020
Special Detailed Inspection of Outer Wing Bottom Skin Upper and Lower Surfaces around Access Panel Cutouts in Rib-Bays 8-9, 9-10....
WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______ START A TASK ON OR NEAR:
-
THE FLIGHT CONTROLS
-
THE FLIGHT CONTROL SURFACES
-
THE LANDING GEAR AND THE RELATED DOORS
-COMPONENTS THAT MOVE.
WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______ GEAR.
1. Reason for the Job
__________________
Refer to the MPD TASK: 572139-02 Special detailed inspection of outer wing bottom skin upper and lower surfaces around access panel cutouts in rib bays 8-9, 9-10, 10-11, 11-12 and 12-13.
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific safety barriers No specific warning notices No specific adjustable access platform 2 m (6 ft. 7 in.) 98D27803500001 1 TOOL-ZERO LOCKING, FLAP SLAT CTL LEVER
B. Consumable Materials
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
Material No. 11-026 GB DEF-STAN 68-148/1 SOLVENT GENERAL PURPOSE (Ref. 20-31-00) Material No. 19-003 USA AMS 3819 LINT-FREE COTTON CLOTH (Ref. 20-31-00)
1EFF : ALL 1 57-21-00Page A608 1 1 Nov 01/04R 1 1 1CES 1
C. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION ------------------------------------------------------------------------------- 中國航空網 www.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：A320飛機維護手冊 AMM WINGS 機翼1(142)
