3.  
The person referred to under MCAR-M.801 or the MCAR-M Subpart F approved maintenance organisation should be satisfied that the component in question meets the approved data/standard, such as the required design and modification standards. This may be accomplished by reference to the TC holder or manufacturer's parts catalogue or other approved data (i.e. Service Bulletin). Care should also be exercised in ensuring compliance with applicable ADs and the status of any service life limited parts fitted to the aircraft component. 

AMC M.501(c) – Installation
1.  Standard parts are:
(a)
Parts manufactured in complete compliance with an established industry, State of Design, CAD or other Government specification which includes design, manufacturing,  test and acceptance criteria, and uniform identification requirements. The specification should include all information necessary to produce

and verify conformity of the part. It should be published so that any party may manufacture the part. Examples of specifications are National Aerospace Standards (NAS), Army-Navy Aeronautical Standard (AN), Society of Automotive Engineers (SAE), SAE Sematec, Joint Electron Device Engineering Council, Joint Electron Tube Engineering Council, and American National Standards Institute (ANSI), EN Specifications etc…

(b)
For sailplanes and powered sailplanes, non-required instruments and/or equipment certified under the provision of EASA CS 22.1301(b), if those instruments or equipment, when installed, functioning, functioning improperly or not functioning at all, do not in itself, or by its effect upon the sailplane and its operation, constitute a safety hazard.

“Required” in the term “non-required” as used above means required by the applicable airworthiness code (EASA CS 22.1303, 22.1305 and 22.1307) or required by the relevant operating regulations and the applicable Rules of the Air or as required by Air Traffic Management (e.g. a transponder in certain controlled airspace). 
Examples of equipment which can be considered standard parts are electrical variometers, bank/slip indicators ball type, total energy probes, capacity bottles (for variometers), final glide calculators, navigation computers, data logger / barograph /turnpoint camera, bug-wipers and anti-collision systems.
Equipment which must be approved in accordance to the airworthiness code shall comply with the applicable ETSO or equivalent and is not considered a standard part
(e.g. oxygen equipment). 
2.  
To designate a part as a standard part the TC holder may issue a standard parts manual accepted by the State of Design of original TC holder or may make reference in the parts catalogue to a national/international  specification  (such as a standard diode/capacitor etc) not being an aviation only specification for the particular part.

3.  
Documentation accompanying standard parts should clearly relate to the particular parts and contain a conformity statement plus both the manufacturing and supplier source. Some material is subject to special conditions such as storage condition or life limitation etc. and this should be included on the documentation and / or material packaging. 

4.  
A CAD Form 1 or equivalent is not normally issued and therefore none should be expected.

AMC M.501 (d) – Installation
1.  
Consumable material is any material which is only used once, such as lubricants, cements, compounds, paints, chemicals dyes and sealants etc.

2.  
Raw material is any material that requires further work to make it into a component part of the aircraft such as metals, plastics, wood, fabric etc.

3.  
Material both raw and consumable should only be accepted when satisfied that it is to the required specification. To be satisfied, the material and or its packaging should be marked with the specification and where appropriate the batch number.
　
中國(guó)航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：馬爾代夫民航法規(guī) MCAR-M Continuing Airworthiness(52)