曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

BOEING PROPRIETARY - Copyright#Unpublished Work - See title page for details
SUBTASK 27-41-11-860-002
(7) Set the stabilizer trim cutout switches to the CUTOUT position.
NOTE: The stabilizer trim cutout switches are installed on the control stand.
SUBTASK 27-41-11-860-003
(8) Open these circuit breakers and install safety tags:
CAPT Electrical System Panel, P18-1
Row Col Number Name
C 2 C00849 AFCS STABILIZER TRIM
CAPT Electrical System Panel, P18-2
Row Col Number Name
C 8 C00544 FLIGHT RECORDER POSITION SENSOR
F/O Electrical System Panel, P6-2
Row Col Number Name
B 10 C00207 FLIGHT CONTROL STAB TRIM CONT
D 10 C00840 FLIGHT CONTROL STAB TRIM ACTUATOR
SUBTASK 27-41-11-860-011
(9) Open the following circuit breaker (if installed):
(a) Open this circuit breaker and install safety tag:
CAPT Electrical System Panel, P18-3
Row Col Number Name
A 15 C00644 EXTERIOR LIGHTING LOGO ILLUM
SUBTASK 27-41-11-860-004
(10) If necessary, use the stabilizer trim wheel on the control stand to set the horizontal stabilizer at
zero degrees (4 units of trim).
SUBTASK 27-41-11-480-001
(11) Install the lock, SPL-1672 on the stabilizer trim wheel at the control stand (Figure 402):
(a) Turn the trim wheel to put the handle at the top of the wheel.
(b) Adjust the height of the trim lock to put the trim wheel handle correctly on the yoke.
(c) Install the pin through the yoke.
(d) Install the safety pin.
SUBTASK 27-41-11-410-004
(12) Open this access panel:
Number Name/Location
318BR Tailcone Access Door
SUBTASK 27-41-11-010-001
(13) To gain access for the left horizontal stabilizer, do this step:
737-600/700/800/900
AIRCRAFT MAINTENANCE MANUAL
EFFECTIVITY
GUN ALL 27-41-11
Page 403
Jun 10/2005
D633A101-GUN
BOEING PROPRIETARY - Copyright#Unpublished Work - See title page for details
Open these access panels:
Number Name/Location
331A Horizontal Stabilizer, Gap Cover
331AZ Horizontal Stabilizer, Access Panel, Inboard L.E.
Closure Rib
332AB Horizontal Stabilizer, Gap Cover, Horizontal
Stabilizer to Body
333AB Horizontal Stabilizer, Gap Cover, Horizontal
Stabilizer to Body
333AZ Horizontal Stabilizer, Access Panel, Inboard T.E.
Closure Rib
SUBTASK 27-41-11-010-002
(14) To gain access for the right horizontal stabilizer, do this step:
Open these access panels:
Number Name/Location
341A Horizontal Stabilizer, Gap Cover
341AZ Horizontal Stabilizer, Access Panel - Inbd L.E.
Closure Rib
342AB Horizontal Stabilizer, Gap Cover - H. Stab. to Body
343AB Horizontal Stabilizer, Gap Cover - H. Stab. to Body
343AZ Horizontal Stabilizer, Access Panel - Inbd T.E.
Closure Rib
F. Horizontal Stabilizer Removal
SUBTASK 27-41-11-480-002
(1) Install the sling, SPL-2035 (Figure 404):
(a) Remove the bolts [1] and bolts [2] from the stabilizer top surface.
CAUTION: MAKE SURE YOU INSTALL THE HOISTING SLING CORRECTLY WHEN YOU
REMOVE THE HORIZONTAL STABILIZER WITH OR WITHOUT THE ELEVATOR
INSTALLED. IF YOU DO NOT INSTALL THE HOISTING SLING CORRECTLY FOR
THE REMOVAL OF THE HORIZONTAL STABILIZER, YOU CAN CAUSE DAMAGE
TO EQUIPMENT.
(b) Attach the sling, SPL-2035 to the horizontal stabilizer with fasteners.
(c) Attach a hoist to the sling, SPL-2035.
CAUTION: YOU MUST CAREFULLY LIFT THE HOISTING SLING. A SUDDEN MOVEMENT OF
THE HOISTING SLING CAN CAUSE DAMAGE TO THE HORIZONTAL STABILIZER.
(d) Apply sufficient tension to the sling to lift the weight of the horizontal stabilizer.
SUBTASK 27-41-11-020-001
CAUTION: RELEASE THE CONNECTION SLOWLY AND LET THE PRESSURE DECREASE BEFORE
YOU COMPLETELY REMOVE THE HYDRAULIC LINES. IF YOU DISCONNECT A
HYDRAULIC LINE WHEN IT HAS PRESSURE, A SPRAY OF THE HYDRAULIC FLUID
CAN CAUSE INJURY TO PERSONS.
(2) Disconnect the hydraulic line [25] of the elevator tab installed aft of the stabilizer rear spar.
SUBTASK 27-41-11-020-008
(3) Disconnect the following electrical connectors:
737-600/700/800/900
AIRCRAFT MAINTENANCE MANUAL
EFFECTIVITY
GUN ALL 27-41-11
Page 404
Jun 10/2006
D633A101-GUN
BOEING PROPRIETARY - Copyright#Unpublished Work - See title page for details
(a) Flight recorder position sensor
(b) Exterior logo light (if installed).
SUBTASK 27-41-11-020-002
(4) If the elevator is attached to the horizontal stabilizer, then do this step:
(a) Open this access panel:
Number Name/Location
318BR Tailcone Access Door
or
Open this access panel:
Number Name/Location
317AL Tail Cone Access Door
(b) Remove the nut [24], washer [23], washer [22], and bolt [21] to disconnect the elevator
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-600-700-800-900 AIRCRAFT MAINTENANCE MANUAL飛機維護手冊3(125)