曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

(Opt Part #: C27028-1, Supplier: 81205, A/P Effectivity: 737-100, -200,
-200C, -300, -400, -500, -600, -700, -700C, -700ER, -700QC, -800, -900,
-900ER, -BBJ)
(Opt Part #: F80248-8, Supplier: 81205, A/P Effectivity: 737-100, -200,
-200C, -300, -400, -500)
C. Location Zones
Zone Area
316 APU Compartment - Right
334 Left Horizontal Stabilizer - Elevator
335 Left Horizontal Stabilizer - Tip
344 Right Horizontal Stabilizer - Elevator
737-600/700/800/900
AIRCRAFT MAINTENANCE MANUAL
EFFECTIVITY
GUN ALL 27-31-31
Page 401
Oct 10/2007
D633A101-GUN
BOEING PROPRIETARY - Copyright#Unpublished Work - See title page for details
(Continued)
Zone Area
345 Right Horizontal Stabilizer - Tip
D. Access Panels
Number Name/Location
318BR Tailcone Access Door
E. Prepare for the Removal
SUBTASK 27-31-31-860-001
(1) Do this task: Remove Pressure from the Elevator Hydraulic Systems A and B,
TASK 27-31-00-800-802.
SUBTASK 27-31-31-010-001
(2) Remove this access panel:
Number Name/Location
318BR Tailcone Access Door
SUBTASK 27-31-31-480-001
(3) Install the rig pin E-5 from rig pin kit, SPL-1585 in the aft control quadrant (Figure 401).
SUBTASK 27-31-31-220-001
(4) Measure and record the elevator tab position:
NOTE: Measuring and recording the elevator tab position before you remove the tab may
improve the manual reversion success rate, if the tab needs to be adjusted after
installation. The tab position can be measured with the fixture, SPL-1686, installed on
the second elevator tab hinge (from inboard). The tab position can also be measured
using two pointers with one attached to the elevator and one attached to the elevator
tab. To get an accurate measurement when you re-install the tab, you will have to mark
the position of the edge of the elevator and elevator tab on the pointers so that they can
be re-installed at the same locations when you do the measurements to re-install the
elevator tab.
(a) If the same tab will be re-installed, then do the following prior to tab removal:
1) Make sure that the elevator tab meets the freeplay limits. To check the freeplay limits,
do this task: Elevator Tab Freeplay - Check, TASK 27-31-32-200-801 or Elevator Tab
Freeplay - Check, TASK 27-31-32-200-802.
(b) While you move the elevator trailing edge down, align the projected center of the elevator
trailing edge with the index mark within +/- 0.04 inch (1.0 millimeter), or less.
1) Measure and record the elevator tab position.
F. Elevator Tab Removal
SUBTASK 27-31-31-020-001
(1) Remove the bolts [24] from the access panel [23] to get access to the elevator tab pushrods [25].
GUN 156, 201-204, 206 PRE SB 737-55A1080; AIRPLANES WITH FOUR ELEVATOR TAB HINGES
SUBTASK 27-31-31-020-002
(2) Remove the bolts [38] and bolts [53] from the hinge cover [39] and hinge covers [46] to get
access to the elevator tab hinges.
GUN ALL
737-600/700/800/900
AIRCRAFT MAINTENANCE MANUAL
EFFECTIVITY
GUN ALL 27-31-31
Page 402
Jun 10/2007
D633A101-GUN
BOEING PROPRIETARY - Copyright#Unpublished Work - See title page for details
SUBTASK 27-31-31-020-004
(3) Remove the elevator tab assembly [22]:
(a) Remove the pins [54], nuts [30], washers [31], bushings [32], and bolts [33] from the
elevator tab assembly [22] and elevator tab pushrods [25]. Discard the pins [54].
(b) Hold the elevator tab assembly [22] while you disconnect the elevator tab assembly [22]
from the elevator [21]:
1) Remove the pin [44], nut [45], washer [43], bushing [42], washer [41], and bolt [40].
Discard the pin [44].
2) Remove the pins [51], nuts [52], washers [50], bushings [49], washers [48], and bolts
[47]. Discard the pins [51].
CAUTION: DO NOT LET THE BONDING JUMPERS SUPPORT THE WEIGHT OF THE
ELEVATOR TAB ASSEMBLY [22]. THE BONDING JUMPERS CAN BE
DAMAGED.
3) Remove nut [26], washers [27], and bolt [29] to disconnect the bonding jumper [28] from
the elevator [21].
4) Remove nut [34], washers [35], and bolt [37] to disconnect the bonding jumper [36] from
the elevator [21].
(c) Remove the elevator tab assembly [22].
------------------------- END OF TASK ---------------------------
737-600/700/800/900
AIRCRAFT MAINTENANCE MANUAL
EFFECTIVITY
GUN ALL 27-31-31
Page 403
Oct 10/2006
D633A101-GUN
BOEING PROPRIETARY - Copyright#Unpublished Work - See title page for details
Elevator Rig Pin Installation
Figure 401/27-31-31-990-801
737-600/700/800/900
AIRCRAFT MAINTENANCE MANUAL
EFFECTIVITY
GUN ALL 27-31-31
Page 404
Oct 10/2005
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-600-700-800-900 AIRCRAFT MAINTENANCE MANUAL飛機維護手冊3(43)