(17)
 AMM 32-51-00/501, Nose Wheel Steering System

 (18)
 WDM 32-45-12, WDM 33-42-13

 C.
Access

 (1)  
Location Zone
 715 Nose Landing Gear

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 32-21-01
 ALL  ú ú 01 Page 401 ú Feb 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL

TRUNNION
LINKSEE A BOLT
RETAINER FWD
B
HYDRAULIC LINES BRACKET PIVOT LINKS
RETAINER
BOLT
HYDRAULIC LINES
A-A
DRIVE CRANK 
FOR THE AFT 
DOOR 
BULKHEAD 
LINK 
TRUNNION  NWS2A  A 
NWS2B 
FWD  TRUNNION LINK  A 

ATTACHSEE B BOLT
A
Hydraulic Line and Steering Linkage for the Nose Landing Gear
Figure 401

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 32-21-01
 ALL  ú ú 01 Page 402 ú Oct 15/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 D. Prepare for the removal
 S 864-002
 (1)  Decrease the pressure on the hydraulic power No. 1 system
 (AMM 29-11-00/201).

 S 494-070
 WARNING: YOU MUST CAREFULLY INSTALL THE GROUND LOCKS IN ALL LANDING
_______ GEAR. AN ACCIDENTAL RETRACTION OF THE LANDING GEAR CAN CAUSE INJURY TO PERSONS AND DAMAGE TO EQUIPMENT.
 (2) Install the ground locks in all landing gear (AMM 09-11-00/201).
 S 494-071
 WARNING: YOU MUST CAREFULLY DO THE STEPS IN THE TASK BELOW TO INSTALL
_______ THE DOOR LOCKS ON THE LANDING GEAR DOORS. THE DOORS CAN CLOSE QUICKLY IF YOU DO NOT INSTALL THE DOOR LOCKS CORRECTLY. THIS CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
 (3)  
Do this task: "Installation of the Door Locks on the Nose Landing Gear" (AMM 32-00-30/201).

 S 034-005

 (4)  
Disconnect the left and the right door operator rods from the drive cranks on the nose gear trunnion (Fig. 402).

 S 014-006

 (5)  
Remove the wheel well doors for the aft nose landing gear
 (AMM 32-22-02/401).

 S 494-007

 (6)  
Install the rigging pin NS-4 in the cable compensator aft of the nose wheel well (AMM 32-51-00/501).

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 32-21-01
 ALL  ú ú 01 Page 403 ú Oct 15/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 S 034-008
 (7)  
Remove the pivot link bolt to disconnect the bulkhead link from the trunnion pivot link (Fig. 401).

 S 034-009

 (8)  
Disconnect and seal the hydraulic lines at the left trunnion bracket (Fig. 401).

 S 864-010

 (9)  
Open these circuit breakers and attach DO-NOT-CLOSE tags:

 (a)  
P7 Overhead Circuit Breaker Panel
 1) 7G25 NOSE GR STRG PRI
 2) 7G26 NOSE GR STRG ALTN

 S 864-011
 (10)
 Make sure these switches on the P5 panel are in the OFF position.

 (a)  
Install DO NOT OPERATE placards:

 -NOSE GEAR TAXI LIGHT
 -RIGHT RWY TURN OFF LT
 -LEFT RWY TURN OFF LT.
 S 034-012
 (11)
 Remove the main box cover (J27) of the control panel for the nose wheel.

 (a)  
Disconnect the electrical connectors D2693, and D2694 and the tape wire bundle to the nose gear trunnion.

 NOTE: The box of the control panel for the nose
____ wheel is at the right panel of the aft wheel well. You can get access through the right aft door of the nose gear.
 S 034-013
 (12) Remove the clamps and the electrical conduit from the wall of the aft wheel well.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 起落架 LANDING GEAR 3(102)