S 494-074

 (19)
 Do this task:  "Installation of the Door Locks on the Body Landing Gear" (AMM 32-00-30/201).

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 32-21-01
 ALL  ú ú 02 Page 418 ú Oct 15/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL

 S 224-048
 (20)
 Examine the position of the closed stop on Station 340 bulkhead in the wheel well of the nose landing gear (Fig. 404).

 (a)  
Put the control handle of the landing gear in the OFF position.

 WARNING: DO NOT MOVE THE NOSE LANDING GEAR AND THE FORWARD DOOR
_______ TOO QUICKLY. THIS WILL CAUSE INJURY TO PERSONS AND CAUSE DAMAGE TO EQUIPMENT.
 (b)  
Make sure all persons and equipment are clear of the nose landing gear and the forward doors.

 (c)  
Put the manual release for the ground door in the open position to release the forward doors.

 (d)  
Put 3/4 inches thick of clay on the top of the stop where meets the torsion link (View Figure 404).

 NOTE: Make sure the surface of the stop is clean and
____
 dry before you apply the clay.

 1)  Apply a layer of lubricant on the top surface of the clay which meets the torsion link.
 (e)  
Jack the airplane for gear retraction (AMM 07-11-02/201).

 (f)  
Put the control handle in the UP position to retract the nose landing gear.

 (g)  
With the nose landing gear down and locked, measure the compressed clay thickness.

 NOTE: The closed clearance (clay thickness) must be 0.50 |.10
____
 inch (12.7 mm |2.5 mm) (Fig. 404).

 (h)  
Adjust the shims to the correct clearance position if it is necessary.

 (i)  
Remove the clay after you get the correct clearance.

 S 864-049
 WARNING:_______DO NOT MOVE THE NOSE LANDING GEAR TOO QUICKLY. THIS WILL CAUSE INJURY TO PERSONS AND DAMAGE TO EQUIPMENT.
 (21)
 Extend the nose landing gear.

 (a)  
Make sure that all persons and equipment are clear of the nose landing gear.

 (b)  
Put the control handle in the DN position to lower the nose landing gear.

 (c)  
Put the control handle in the OFF position.

 (d)  
Put the manual release handle of the ground door in the OPEN position.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 32-21-01
 ALL  ú ú 02 Page 419 ú Jun 18/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
SEE A
BULKHEAD (STA 340)
FWD
BRACKET
CLEARANCE CLOSED
SHIMS  CLAY 
STOP 
(4 LOCATIONS) BOLTS 
Figure 404 A Nose Landing Gear Closure Stop 

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 32-21-01
 ALL  ú ú 02 Page 420 ú Feb 10/93
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 S 094-075
 WARNING:_______ YOU MUST CAREFULLY DO THE STEPS IN THE TASK BELOW TO REMOVE THE
 DOOR LOCKS FROM THE LANDING GEAR DOORS.  THE DOORS CAN CLOSE
 QUICKLY IF YOU DO NOT REMOVE THE DOOR LOCKS CORRECTLY.  THIS

 CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
 (22)
 Do this task:  "Removal of the Door Locks on the Nose Landing Gear" (AMM 32-00-30/201).

 S 094-051

 (23)
 Remove the rigging pin NS-4 from the cable compensator aft of the nose wheel well (AMM 32-51-00/501).

 S 714-052

 (24)
 Do the system test of the extension and retraction for the nose landing gear (AMM 32-34-00/501).
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 起落架 LANDING GEAR 3(109)