(t)  
Move the control handle of the landing gear to the "DN" position.

 (u)  
Remove the rig pin (BD-1 LH, BD-2 RH).

 (v)  
Tighten the fasteners for the actuator rod for the sequence valve.

 (w)  
Tighten the bolts for the serrated fitting.

 I.  
Adjust the outboard shock strut door and the inboard shock strut door (Airplane on Jacks) (Figure 505 and Figure 506).

 NOTE: In this task you will extend and retract the gear many
____ times. The steps to do this are given in the beginning of this task. Use these same steps each time you are required to extend or retract the landing gear.
 S 865-053
 (1)  Make sure that the ground release handle for the doors is in the "Doors Open" position.
 S 865-301
 WARNING: YOU MUST CAREFULLY DO THE STEPS IN THE TASK BELOW TO INSTALL
_______ THE DOOR LOCKS ON THE LANDING GEAR DOORS. THE DOORS CAN CLOSE QUICKLY IF YOU DO NOT INSTALL THE DOOR LOCKS CORRECTLY. THIS CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
 (2)  Make sure the door locks are installed, do this task: "Installation of the Door Locks on the Body Landing Gear" (AMM 32-00-30/201).
 S 035-054
 CAUTION:_______KEEP THE DOOR AND ROD IN THE OPEN POSITION. IF YOU DO NOT MOVE THE DOOR OUT OF THE WORK AREA, YOU CAN CAUSE DAMAGE TO THE DOOR WHEN THE GEAR IS RETRACTED.
 (3)  
Disconnect the linkage rod for the outboard shock strut door from the shock strut.

 (a)  
Make sure the door and the linkage rod are held in the open position, out of the work area.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 32-14-00
 ALL  ú ú 04 Page 518 ú Jun 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 S 035-055
 CAUTION:_______LIMIT THE DOOR AND ROD IN THE OPEN POSITION. IF YOU DO NOT MOVE THE DOOR OUT OF THE WORK AREA, YOU CAN CAUSE DAMAGE TO THE DOOR WHEN THE GEAR IS RETRACTED.
 (4)  
Disconnect the linkage rod for the inboard shock strut door from the shock strut.

 (a)  
Make sure the door and the linkage rod are held in the open position, out of the work area.

 S 865-308
 (5)  
Lift the airplane with jacks such that you can retract the landing gear (AMM 07-11-01/201).

 S 865-309

 (6)  
Put the ground release handle for the doors in the correct position:

 WARNING: MAKE SURE THAT PERSONS AND EQUIPMENT ARE CLEAR OF ALL
_______ CONTROL SURFACES BEFORE YOU SUPPLY HYDRAULIC POWER. AILERONS, RUDDERS, ELEVATORS, FLAPS, SPOILERS, LANDING GEAR, AND THRUST REVERSERS CAN MOVE QUICKLY WHEN YOU SUPPLY HYDRAULIC POWER. THIS CAN CAUSE INJURY TO PERSONS AND DAMAGE TO EQUIPMENT.
 (a) Pressurize the hydraulic system No. 1 (AMM 29-11-00/201).
 WARNING: MAKE SURE THAT ALL PERSONS AND EQUIPMENT ARE CLEAR OF THE
_______ DOOR OPERATION PATH. IF YOU MOVE THE DOORS TOO QUICKLY, YOU CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
 (b)  
Move the ground release handle for the doors to the "Door Closed" position.

 (c)  
Remove the hydraulic pressure from the system No. 1
 (AMM 29-11-00/201).

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 32-14-00
 ALL  ú ú 11 Page 519 ú Jun 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 S 865-310
 WARNING:_______ YOU MUST CAREFULLY DO THE STEPS IN THE TASK BELOW TO REMOVE THE
 DOOR LOCKS FROM THE LANDING GEAR DOORS.  THE DOORS CAN CLOSE
 QUICKLY IF YOU DO NOT REMOVE THE DOOR LOCKS CORRECTLY.  THIS

 CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
 (7)  
Do this task: "Removal of the Door Locks on the Body Landing Gear" (AMM 32-00-30/201).

 S 865-311

 (8)  
Retract the landing gear (follow these steps each time you will retract the landing gear):
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 起落架 LANDING GEAR 3(69)