(8)  
AIPC 32-13-10 Fig. 1

 C.
Access

 (1)  
Location Zone
 755 Body Landing Gear, LH
 765 Body Landing Gear, RH

 D.
Procedure

 S 222-015
 (1)  
Do a check of the points that attach for the worn areas (See Fig. 203, sheet 2 & 3).

 S 642-016

 (2)  
Put the lubricant on all washer surfaces, nuts and threads of bolts immediately before the installation.

 S 432-017

 (3)  
Prepare the lubrication inserts (3) and (6) for installation.

 (a)  
Lightly apply a layer on the O-rings (2 and 7), the lubrication inserts (3 and 6) and the internal surfaces of the apex bolts (1 and 5) with petrolatum.

 (b)  
Move the O-rings into the lubrication inserts.

 (c)  
Install the lubrication inserts in the apex bolts.

 (d)  
Attach the lubrication insert (3) to the bolt (1) with the lock ring (4).

 S 432-018
 (4)  
Lift the lower jury strut into its position.

 S 432-019

 (5)  
Install the apex bolt (5) for the drag strut.

 S 432-020

 (6)  
Tighten the nut (15) to 600 - 1200 pound-inches and install the cross bolt (14).

 S 432-021

 (7)  
Install the apex bolt (1) for the jury strut.

 (a)  
Tighten the nut (19) to 600 - 1200 pound-inches and install the cotter pin (18).

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 32-13-10
 ALL  ú ú 01 Page 205 ú Oct 18/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 S 432-022
 (8)
Install the ground lock in the jury strut (AMM 09-11-00/201).

 S 432-023

 (9)  
Connect the downlock actuator (9) (AMM 32-33-15/401).

 S 432-024

 (10)
 Connect the downlock bungee (12) (AMM 32-33-16/401).

 S 092-025

 (11)
 Remove the strut support slings.

 S 222-026

 (12)
 Make sure you aligned the jury strut assembly and adjust it if it is necessary (See Fig. 202).

 S 862-027

 (13)
 Lower the airplane and remove the jacks (AMM 07-11-01/201).

 S 092-044
 WARNING: YOU MUST CAREFULLY DO THE STEPS IN THE TASK BELOW TO REMOVE THE
_______ DOOR LOCKS FROM THE LANDING GEAR DOORS. THE DOORS CAN CLOSE QUICKLY IF YOU DO NOT REMOVE THE DOOR LOCKS CORRECTLY. THIS CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
 (14)
 Do this task:  "Removal of the Door Locks on the Wing Landing Gear" (AMM 32-00-30/201).

 S 092-045

 (15)
 Do this task:  "Removal of the Door Locks on the Body Landing Gear" (AMM 32-00-30/201).

 TASK 32-13-10-802-029
 4.  Body Gear Jury Strut Adjustment (Fig. 202)_______________________________
 A. Special Tools and Equipment
 (1)
2MIT65B08802-1 - Body Landing Gear Bungee Restraining Tool

 B.
Standard Tools and Equipment

 (1)  
Steel Straightedge - 4 foot long

 (2)  
Scale - graduated in 0.01 inch

 C.
Consumable Materials

 (1)  
D00633 Grease - BMS 3-33 (preferred)

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 32-13-10
 ALL  ú ú 01 Page 206 ú Oct 18/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
AA
SEE A
LOWER JURY
STRUT APEX BOLT
ADJUSTING
SHIM

UPPER JURYBARREL STRUTNUT
STOP PLATE
A
CENTERLINE
JURY STRUT APEX
UPPER JURY STRUT PIN/
BOLT CENTERLINE
DRAG STRUT APEX PIN
A = 0.25 |0.02 INCH

UPPER JURY DRAG STRUT
STRUT PIN APEX
OFF-CENTER DIMENSION A-A
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 起落架 LANDING GEAR 3(21)