曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

are designed to ensure safe vertical separation between
the aircraft and the terrain. These minimum altitude
rules apply to all IFR flights, whether in IFR or VFR
Figure 3-16. Changeover Point Effect on Long Airway or Route Segment.
4 NM
4 NM
2 NM
2 NM
6.7°
4.5°
4.5°
6.7°
70
70
Secondary Areas
Primary Area
Flare
Flare
Figure 3-15. Changeover Points.
22
45
13,000 ft
13,000
V 344
3-13
weather conditions, and whether assigned a specific
altitude or VFR conditions on top.
MINIMUM EN ROUTE ALTITUDE
The minimum enroute altitude (MEA) is the lowest
published altitude between radio fixes that assures
acceptable navigational signal coverage and meets
obstacle clearance requirements between those fixes.
The MEA prescribed for a Federal airway or segment,
RNAV low or high route, or other direct route applies
to the entire width of the airway, segment, or route
between the radio fixes defining the airway, segment,
or route. MEAs for routes wholly contained within
controlled airspace normally provide a buffer above the
floor of controlled airspace consisting of at least 300
feet within transition areas and 500 feet within control
areas. MEAs are established based upon obstacle clearance over terrain and manmade objects, adequacy of
navigation facility performance, and communications
requirements, although adequate communication at the
MEA is not guaranteed.
MINIMUM OBSTRUCTION
CLEARANCE ALTITUDE
The minimum obstruction clearance altitude (MOCA)
is the lowest published altitude in effect between fixes
on VOR airways, off-airway routes, or route segments
that meets obstacle clearance requirements for the entire
route segment. This altitude also assures acceptable navigational signal coverage only within 22 NM of a VOR.
The MOCA seen on the NACO en route chart, may have
been computed by adding the required obstacle clearance (ROC) to the controlling obstacle in the primary
area or computed by using a TERPS chart if the controlling obstacle is located in the secondary area. This figure
is then rounded to the nearest 100 - foot increment, i.e.,
2,049 feet becomes 2,000, and 2,050 feet becomes 2,100
feet. An extra 1,000 feet is added in mountainous areas,
in most cases. The MOCA is based upon obstacle clearance over the terrain or over manmade objects, adequacy
of navigation facility performance, and communications
requirements.
ATC controllers have an important role in helping pilots
remain clear of obstructions. Controllers are instructed
to issue a safety alert if the aircraft is in a position that, in
their judgment, places the pilot in unsafe proximity to
terrain, obstructions, or other aircraft. Once pilots inform
ATC of action being taken to resolve the situation, the
controller may discontinue the issuance of further alerts.
A typical terrain/obstruction alert may sound like this:
“Low altitude alert. Check your altitude immediately.
The MOCA in your area is 12,000.”
MINIMUM VECTORING ALTITUDES
Minimum vectoring altitudes (MVAs) are established
for use by ATC when radar ATC is exercised. The MVA
provides 1,000 feet of clearance above the highest
obstacle in nonmountainous areas and 2,000 feet above
the highest obstacle in designated mountainous areas.
Because of the ability to isolate specific obstacles, some
MVAs may be lower than MEAs, MOCAs, or other
minimum altitudes depicted on charts for a given
location. While being radar vectored, IFR altitude
assignments by ATC are normally at or above the
MVA.
Controllers use MVAs only when they are assured an
adequate radar return is being received from the aircraft. Charts depicting minimum vectoring altitudes
are normally available to controllers but not available
to pilots. Situational awareness is always important,
especially when being radar vectored during a climb
into an area with progressively higher MVA sectors,
similar to the concept of minimum crossing altitude.
Except where diverse vector areas have been established, when climbing, pilots should not be vectored
into a sector with a higher MVA unless at or above the
next sector’s MVA. Where lower MVAs are required
in designated mountainous areas to achieve compatibility with terminal routes or to permit vectoring to an
instrument approach procedure, 1,000 feet of obstacle
clearance may be authorized with the use of Airport
Surveillance Radar (ASR). The MVA will provide at
least 300 feet above the floor of controlled airspace.
The MVA charts are developed to the maximum radar
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：Instrument Procedures Handbook (IPH)儀表程序手冊下(65)