曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

EQUIPMENT.
CAUTION: YOU MUST ATTACH CAPS TO HOLES/PIPES WHEN YOU REMOVE
THE ENGINE. IF YOU DO NOT DO THIS, CONTAMINATION CAN
ENTER THE HOLES/PIPES. THIS CAN CAUSE BLOCKAGE TO THE
AIRPLANE SYSTEMS.
AIRCRAFT
Power Plant DA 40 Series
AMM
Page 202
20 Sep 2007 71-00-00 Doc # 6.02.01
Rev. 5
Oil Hose to
Front of Oil Cooler
Oil Hose to
Rear of Oil Cooler
Fuel Feed
Hose to Firewall
Fuel Pump
Drain
Engine Breather
Fuel Feed from the
Fuel Pump Outlet
Figure 2: Connections at the Rear of the Engine
AIRCRAFT
DA 40 Series
AMM
Power Plant
Doc # 6.02.01
Rev. 5 71-00-00 Page 203
20 Sep 2007
2. Remove/Install the Engine (without the Engine Mount)
A. Equipment
Item Quantity Part Number
Hoist. 1 Commercial.
Engine sling. 1 Commercial.
Engine stand. 1 Commercial.
Airplane jacks. 3 Commercial.
Nose trestle. 1 Commercial.
Wing trestles. 2 Commercial.
B. Remove the Engine
Detail Steps/Work Items Key Items/References
(1) Lift the airplane on jacks and make the airplane
level.
Refer to Section 07-10.
(2) Move the wing trestles into position. Refer to Section 07-10.
WARNING: MAKE SURE THAT THE ENGINE IS SAFE BEFORE YOU DO ANY
WORK ON THE PROPELLER. IF THE ENGINE IS TURNED, THE
PROPELLER CAN CAUSE INJURY OR DEATH.
(3) Set the fuel selector/shut-off valve to CLOSED.
(4) Make sure that the engine is safe:
S Set the ignition switch to OFF.
S Set the throttle to IDLE.
S Set the mixture control to LEAN CUT-OFF.
(5) Remove the engine cowlings. Refer to Section 71-10.
(6) Remove the airplane battery. Refer to Section 24-31.
(7) Disconnect the spark plug cables from the spark
plugs.
(8) Remove the spark plugs and put blanks in the
spark plug holes in the cylinders.
This will stop contamination going into
the engine cylinders.
AIRCRAFT
Power Plant DA 40 Series
AMM
Page 204
20 Sep 2007 71-00-00 Doc # 6.02.01
Rev. 5
LYCOMING LYCOMING
Starter
Cable
Fuel Pressure
Connector
Fuel Flow
Connector
Mixture
Control
Propeller
Control
Manifold Pressure
Connector
LASAR
Connector
Bolt for
Breathers Assy
Engine Mount to
Firewall Bolts
Engine Mount to
Firewall Bolt
EGT and CHT
In-Line Connectors
Figure 3: Left Side of the Engine
AIRCRAFT
DA 40 Series
AMM
Power Plant
Doc # 6.02.01
Rev. 5 71-00-00 Page 205
20 Sep 2007
Detail Steps/Work Items Key Items/References
(9) Remove the cable ties that attach the top lefthand
ignition cable to the propeller control cable.
Remove the 2 nuts/washers/screws that hold the
left-hand fairlead for the top ignition cables.
(10) Release the P-clamps holding the left ignition
cables to the engine-cooling-baffles.
(11) Remove the 2 nuts/washers/screws that attach
the right-hand fairlead for the top ignition cables.
(12) Remove the cable ties attaching the left-side
ignition cables to the engine mount and move the
cables to the rear of the engine.
Note the position of the cable ties.
(13) Release the P-clamps holding the right ignition
cables to the engine cooling baffles.
(14) Remove the cable ties attaching the right side
ignition cables to the engine mount and move the
cables to the rear of the engine.
Note the position of the cable ties.
(15) Remove the cable ties attaching the left side
ignition cables to the right side ignition cables.
Note the position of the cable ties.
(16) Release the three screws which attach the
ignition harness to the left magneto and move the
harness assembly clear of the airplane.
(17) Release the three screws which attach the
ignition harness to the right magneto and move
the harness assembly clear of the airplane.
(18) Disconnect the electrical plugs from the left and
right magnetos.
Move the plugs aft, clear of the engine.
AIRCRAFT
Power Plant DA 40 Series
AMM
Detail Steps/Work Items Key Items/References
Page 206
20 Sep 2007 71-00-00 Doc # 6.02.01
Rev. 5
(19) Remove the exhaust gas temperature probe from
the exhaust manifold:
S Release the worm-drive-clamp which
attaches the probe to the exhaust manifold.
S Remove the probe.
S Remove the cable ties attaching the cable for
the probe to the engine mount.
S Move the cable clear of the engine.
Do this item for each of the four probes.
Note the location of the cable-ties.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：鉆石40系列AMM 3(15)