R  (f) Refer to the match marks and put the wires (4) in position. 
R  (g) Install the nuts (5). 
R  (h) Put the cover (7) in position and install the screws (6). 
R  WARNING : WEAR GOGGLES WHEN YOU REMOVE OR INSTALL THE LOCKWIRE._______ 
R  CUT, REMOVE AND DISCARD THE LOCKWIRE AS YOU DO THE 
R  TASK. LOOSE LOCKWIRE CAN CUT OR BLIND YOU. 
R  (i) Safety the screws (6) with MISCELLANEOUS (Material No. 19-010). 
R  (5) Seal the Splitline Joints 
R  WARNING : MAKE SURE THAT THERE IS A GOOD FLOW OF AIR THROUGH THE WORK_______ 
R  AREA WHEN YOU USE SPECIAL MATERIALS. 
R  IF YOU GET ONE OF THESE MATERIALS ON YOUR SKIN, IN YOUR 
R  MOUTH OR IN YOUR EYES : 
R  -FLUSH IT AWAY WITH A FLOW OF CLEAN WATER FOR BETWEEN 10 
R  AND 15 MINUTES. 
R  -GET IMMEDIATE MEDICAL AID IF IRRITATION OCCURS. 
R  DO NOT BREATHE THE FUMES FROM THE MATERIAL. 
R  DO NOT SMOKE WHEN YOU USE THE MATERIAL. 
R  DO NOT USE THE MATERIAL NEAR A FLAME, SPARKS OR SOURCES OF 
R  HEAT. 
R  THESE MATERIALS ARE DANGEROUS : THEY ARE POISONOUS, 
R  FLAMMABLE AND SKIN IRRITANTS. 
R  WARNING : OBEY THE MANUFACTURER'S INSTRUCTIONS WHEN YOU USE_______ 
R  THIS/THESE MATERIAL/S. 
R  USE PROTECTIVE CLOTHING, RUBBER GLOVES, GOGGLES AND A MASK. 
R  (a) Apply new BONDING AND ADHESIVE COMPOUNDS (Material No. 08-004A) 
R  into all the splitline joints. 
R  **ON A/C 106-149, 201-299,
 Subtask 25-31-41-420-050-A
 A. Connect the Galley Splitline
 NOTE : This procedure is only necessary if you removed the galley from____
 the cabin.
 NOTE : Unless specified TORQUE all nuts, bolts and screws (Ref. TASK 20-____
 21-11-911-001).

 CES

R  (1) Connect the Galley at the Splitline (Ref. Fig. 405B/TASK 25-31-41-991-020-A)
 WARNING : SUPPORT THE UNIT/ASSEMBLY OR IT WILL FALL AND BECOME_______ DAMAGED OR INJURE PERSONNEL. THE UNIT/ASSEMBLY IS HEAVY.
 (a) Prevent damage to the component interface and the adjacent area.
 (b) Carefully lift the galley modules (30) and (31) and put them in position in the aircraft.
 (c) Install the strips (32).
 (d) Install the screws (29) in the galley modules (30) and (31).
R  (2) Connect the Electrical Connections (Ref. Fig. 405B/TASK 25-31-41-991-020-A)
 (a) Remove the blanking caps from the electrical connectors.
 (b) Make sure that the electrical connectors are clean and in the correct condition.
 (c) Connect the electrical connectors (6) to the electrical connectors (5).
 NOTE : Install cable ties as necessary to attach the electrical____ cables at the galley splitline.
 (d) Put the bonding strap (8) in position and install the washers (7) and the screw (9).
R  (3) Install the Air Connections (Ref. Fig. 405B/TASK 25-31-41-991-020-A)
 (a) Remove the blanking plugs from the disconnected line ends.
 (b) Connect the hose (10) to the hose (12) and install the cable tie (11).
R  (4) Install the Extractor (Ref. Fig. 405B/TASK 25-31-41-991-020-A)
 (a) Put the extractor (1) in position and install the screws (2).

 (5) Install the Potable Water and Drain Connections R (Ref. Fig. 405B/TASK 25-31-41-991-020-A)
 (a)
 Remove the blanking plugs from the disconnected line ends.

 (b)
 Put the clamps (25) in position on the hoses (24), connect the hoses (24) to the water drains (26) and tighten the clamps (25).

 (c)
 Connect the pipes (28) to the unions (27).

 (d)
 Put the clamp (22) in position on the hose (23), connect the hose

 (23) to the sink (21) and tighten the clamp (22).

 (e)
 Put the water spigot (20) in position in the ferrule (19).

 (f)
 Install the washer (18) and the nut (17).

 (g)
 Connect the pipe (16) to the water spigot (20).

 (h)
 Connect the ring (13) to the retainer (14) on the water drain valve (15).

 (i) Connect the pipes (4) to the pipes (3).
 Subtask 25-31-41-420-062-A

 B. Installation of the Galley Unit NOTE : Unless specified TORQUE all nuts, bolts and screws (Ref. TASK 20-
____
 21-11-911-001).

 (1) Install the Lower Attachments
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM EQUIPMENT/FURNISHINGS 設備3(11)