NOTE : A/C NOSE-DOWN <------> PITCH CMD position is negative.
____
A/C NOSE-RIGHT <-----> YAW CMD position is negative.
A/C R WING DOWN <----> ROLL CMD position is negative.
J. Discrete Outputs
(1) FCDC1
-------------------------------------------------------------------------------NAME ELECTRICAL LEVEL TO SIGNAL STATUS -------------------------------------------------------------------------------CAPT R PRIORITY LT ON GND/O C ANN LT CAPT BOARD GND=ON CAPT G PRIORITY LT ON GND/O C ANN LT CAPT BOARD GND=ON FCDC VALID GND/O C FCDC2 GND=VALID F/O R PRIORITY LT ON GND/O C ANN LT F/O R RLY GND=ON F/O G PRIORITY LT ON GND/O C ANN LT F/O G RLY GND=ON (2) FCDC2
-------------------------------------------------------------------------------NAME ELECTRICAL LEVEL TO SIGNAL STATUS -------------------------------------------------------------------------------CAPT R PRIORITY LT ON GND/O C ANN LT CAPT R RLY GND=ON CAPT G PRIORITY LT ON GND/O C ANN LT CAPT G RLY GND=ON FCDC VALID GND/O C FCDC1 GND=VALID F/O R PRIORITY LT ON GND/O C ANN LT F/O R BOARD GND=ON F/O G PRIORITY LT ON GND/O C ANN LT F/O G BOARD GND=ON
CONCENTRATOR - FLIGHT CONTROL DATA (FCDC) (3CE1,3CE2) - REMOVAL/INSTALLATION____________________________________________________________________________
TASK 27-95-34-000-001
Removal of the FCDC (3CE1,3CE2)
1. Reason for the Job__________________
Self Explanatory
2. Job Set-up Information______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific No specific No specific blanking capscircuit breaker(s) safety clip(s)access platform 1.6 m (5 ft. 3 in.)
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
R R 31-32-00-860-006 27-95-34-991-001 Procedure to Get Access to the SYSTEM REPORT/TEST F/CTL PageFig. 401
3. Job Set-up__________
R Subtask 27-95-34-810-050
R A. Trouble Shooting Data
R R R R R R R R R (1) You can print the Trouble Shooting Data (TSD) as follows: - get access to the SYSTEM/REPORT/TEST (Ref. TASK 31-32-00-860-006). - on this page, push the line key adjacent to the EFCS1 and/or EFCS2 indication. - on this page, push the line key adjacent to the LAST LEG REPORT indication. - on this page, push the line key adjacent to the failure(s) to get the TROUBLE SHOOTING DATA page. - print the TROUBLE SHOOTING DATA page.
Subtask 27-95-34-865-050
R B. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------FOR 3CE1
49VU FLIGHT CONTROLS/FCDC1/SPLY 20CE1 B10 FOR 3CE2 121VU FLIGHT CONTROLS/FCDC2/SPLY 20CE2 Q20
Subtask 27-95-34-010-050
R C. Get Access
(1)
Put the access platform in position.
(2)
Open the access door 824.
4. Procedure
_________
(Ref. Fig. 401/TASK 27-95-34-991-001)
Subtask 27-95-34-020-050
A. Removal of the FCDC
(1)
Loosen the nuts (4).
(2)
Lower the nuts (4).
(3)
Pull the FCDC (1) on its rack (3) to disconnect the electrical connectors (2).
(4)
Remove the FCDC (1).
(5)
Put blanking caps on the disconnected electrical connectors (2).
Flight Control Data Concentrator (FCDC)
Figure 401/TASK 27-95-34-991-001
1EFF : ALL 1 27-95-34 Page 403
1 1 Feb 01/98
1 1
1CES 1
TASK 27-95-34-400-001
Installation of the FCDC (3CE1,3CE2)
1.
Reason for the Job
__________________
Self Explanatory
2.
Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FLIGHT CONTROLS 飛行操縱9(110)
