-------------------------------------------------------------------------------
PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------R **ON A/C ALL
R 122VU FLIGHT CONTROLS/WTB/FLP/SYS1 10CV S07 R 122VU FLIGHT CONTROLS/WTB/SLT/SYS1 9CV S06
Subtask 27-92-16-860-052
F. Aircraft Maintenance Configuration
(1)
On the overhead panel 23VU make sure that :
-The FLT CTL/ELAC 1 and FLT CTL/SEC 1 pushbutton switches are pushed (on these pushbutton switches, the FAULT and OFF legends are off).
(2)
On the overhead panel 24VU make sure that :
-The FLT CTL/ELAC 2, FLT CTL/SEC 2 and FLT CTL/SEC 3 pushbutton switches are pushed (on these pushbutton switches, the FAULT and OFF legends are off).
Subtask 27-92-16-710-050
G. Do this test :
-------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
1.
On the center pedestal, on one The MCDU shows the MCDU MENU page.
MCDU, push the MCDU MENU mode
key.
2.
Push the line key adjacent to the The MCDU shows the CFDS MENU page.
the CFDS indication.
3.
Push the line key adjacent to the The MCDU shows the SYSTEM REPORT/TEST SYSTEM REPORT/TEST indication. page.
4.
Push the line key adjacent to the The MCDU shows the F/CTL page.
F/CTL indication.
5.
Push the line key adjacent to the The MCDU shows the EFCS 1 page.
EFCS 1 indication.
6.
Push the line key adjacent to the The MCDU shows the EFCS 1 GROUND SCAN GROUND SCAN indication. page.
-------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
7.
Push the line key adjacent to the
START GROUND SCAN indication and
wait two minutes.
8.
Push the line key adjacent to the
GROUND SCAN STOP indication.
9.
Push the line key adjacent to the Make sure that the MCDU shows no
GROUND REPORT indication. accelerometers (12CE1,12CE2,12CE3,12CE4) failure message.
10.
On the MCDU, push the line key The MCDU shows the MCDU MENU page.
adjacent to the RETURN
indication until the CFDS menu
page comes into view.
5. Close-up
________
R **ON A/C 001-049, 051-099, 101-149, 201-299, 301-399,
Subtask 27-92-16-410-050
A. Close Access
NOTE : If necessary, adjust the clock (Ref. TASK 31-21-00-750-002).
____
(1)
Make sure that the work area is clean and clear of tool(s) and other items.
(2)
Install the sidewall panel:
FOR 12CE1, 12CE3
131MW
FOR 12CE2, 12CE4
132MW
(3)
Close the access door 825.
(4)
Install the protective cover on the battery power center 105VU.
(5)
Tighten the two screws.
(6)
Close the access door 822.
(7)
Remove the access platform(s).
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FLIGHT CONTROLS 飛行操縱9(27)
