(3) If the wear of the bushes is not in the tolerances.
(a)
Replace the bushes (Ref. TASK 52-10-00-915-001).
(b)
Or replace the parts on which they are installed.
5. Close-up
________
Subtask 52-13-14-420-064
A. Installation of the Door-Damper and Emergency-Operation Cylinder
(1)
Install the door-damper and emergency-operation cylinder (Ref. TASK 52-13-14-400-001).
(2)
Install the telescopic rod (Ref. TASK 52-13-14-400-001).
Subtask 52-13-14-865-074
B. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s): 13WN, 15WN, 48WV
Subtask 52-13-14-410-077
C. Close Access
(1)
Obey the special precautions after the work on the door (Ref. TASK 52-10-00-860-002).
(2)
Remove the ground support and maintenance equipment, the special and standard tools and all other items.
(3)
Make sure that the work area is clean and clear of tool(s) and other items.
1EFF : ALL 1 52-13-14Page 614 1 1 Feb 01/98 1 1 1CES 1
(4) Close the FWD passenger/crew door 832 or 842 (Ref. TASK 52-10-00-410-
001).
(5) Remove the access platform(s). Subtask 52-13-14-862-053
D. De-energize the ground service network (Ref. TASK 24-42-00-862-001)
1EFF : ALL 1 52-13-14Page 615 1 1 Feb 01/98 1 1 1CES 1
SEAL - DOOR - REMOVAL/INSTALLATION
__________________________________ TASK 52-13-18-000-001 Removal of the Door Seal
1.
Reason for the Job
__________________
Self Explanatory
2.
Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific access platform 3.50 m (11 ft. 6 in.)
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
52-10-00-010-001 Opening of the Passenger/Crew Door 52-10-00-860-001 Special Precautions before Work on the Passenger/Crew Door 52-13-18-991-001 Fig. 401
3. Job Set-up
__________ Subtask 52-13-18-010-055
A. Get Access WARNING : DO NOT OPEN THE PASSENGER/CREW DOOR IF THE WIND SPEED IS MORE
_______
THAN 65 KNOTS.
WARNING : BEFORE YOU START WORK ON THE DOOR, MAKE SURE THAT:
_______
-
THE EMERGENCY CONTROL HANDLE IS IN THE DISARMED POSITION WITH THE SAFETY PIN INSTALLED.
-
THE PERCUSSION LEVER OF THE DOOR-DAMPER AND EMERGENCY-OPERATION CYLINDER IS IN THE DISARMED POSITION WITH THE SAFETY PIN INSTALLED.
1EFF : ALL 1 52-13-18Page 401 1 1 Feb 01/98 1 1 1CES 1 WARNING : STOP THE OPENING PROCEDURE IF THE RED WARNING LIGHT FLASHES.
_______ RESIDUAL PRESSURE COULD CAUSE THE DOOR TO OPEN WITH A SUDDEN FORCE AND INJURE PERSONS AND/OR DAMAGE THE AIRCRAFT.
(1)
Put the access platform in position in the zone 832 (842).
(2)
Open the applicable passenger/crew door 832, 842 (Ref. TASK 52-10-00-010-001).
(3)
Obey the special precautions before you start work on the door. (Ref. TASK 52-10-00-860-001)
4. Procedure
_________ Subtask 52-13-18-020-052
A. Removal of the Door Seal.
(Ref. Fig. 401/TASK 52-13-18-991-001)
(1)
Remove the nuts (2) of the retainer (8), then the retainer (8) and the screws (21).
(2)
Remove the nuts (2) of the retainer (9), then the retainer (9) and the screws (21).
(3)
Remove the nuts (2) of the retainer (10), then the retainer (10) and the screws (21).
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM DOORS 艙門2(106)
