Weight (98D52103501000) for Escape Slide 52-10-00-480-001 Installation of the Passenger/Crew Door Ballast Weight (98D52103501000) for Escape Slide/Raft 52-10-00-860-001 Special Precautions before Work on the Passenger/Crew Door 52-10-00-860-002 Special Precautions after Work on the Passenger/Crew Door 56-21-13-100-002 Cleaning the Outer Surface of the Outer Window Panes
3. Job Set-up
__________
WARNING : DO NOT OPEN THE PASSENGER/CREW DOOR IF THE WIND SPEED IS MORE THAN
_______
65 KNOTS.
WARNING : BEFORE YOU START WORK ON THE DOOR, MAKE SURE THAT:
_______
-
THE EMERGENCY CONTROL HANDLE IS IN THE DISARMED POSITION WITH THE SAFETY PIN INSTALLED.
-
THE PERCUSSION LEVER OF THE DOOR-DAMPER AND EMERGENCY-OPERATION CYLINDER IS IN THE DISARMED POSITION WITH THE SAFETY PIN INSTALLED.
WARNING : STOP THE OPENING PROCEDURE IF THE RED WARNING LIGHT FLASHES.
_______ RESIDUAL PRESSURE COULD CAUSE THE DOOR TO OPEN WITH A SUDDEN FORCE AND INJURE PERSONS AND/OR DAMAGE THE AIRCRAFT.
1EFF : ALL 1 52-13-00Page 302 1 1 Feb 01/04 1 1 1CES 1 1EFF : ALL 1 52-13-00Page 303 1 1 Nov 01/03 1 1 1CES 1
Subtask 52-13-00-010-059
A. Get Access
R R (1) Put an ACCESS PLATFORM 4M (13 FT) in position at the aft passenger/crew door:
R (a) For the left passenger/crew door at the zone 832.
R (b) For the right passenger/crew door at the zone 842.
R (2) Open the aft passenger/crew door 832 (842) (Ref. TASK 52-10-00-010-001).
(3) Obey the special precautions before you start work on the door (Ref. TASK 52-10-00-860-001).
Subtask 52-13-00-865-052
B. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------121VU EIS/SLIDES/ARM AND WARN/FLT 15WN P11 121VU EIS/SLIDES/ARM AND WARN/GND 13WN P10 121VU EIS/SDAC1 AND 2/DOOR/DET/PAX 48WV P05
**ON A/C 001-002,
Subtask 52-13-00-010-060
R C. Removal of the Escape-Slide Pack-Assembly
(1) Remove the door lining panels: (Ref. TASK 25-23-46-000-002)
R (a) For the left door: 832AZ.
R (b) For the right door: 842AZ.
(2) Remove the escape slide (Ref. TASK 25-62-44-000-002).
R R (3) Install the BALLAST WEIGHT - PASSENGER CREW DOOR (98D52103501000), (Ref. TASK 52-10-00-480-001).
(4) Remove the door insulation.
R **ON A/C 003-049, 051-099, 101-149, 151-199, 201-299, 301-399, 401-499,
Subtask 52-13-00-010-060-A
C. Removal of the Escape-Slide Raft Pack-Assembly
(1)
Remove the door lining panels:
(Ref. TASK 25-23-46-000-002)
(a)
For the left door: 832AZ.
(b)
For the right door: 842AZ.
(2)
Remove the escape-slide raft (Ref. TASK 25-62-44-000-002).
(3)
Install the BALLAST WEIGHT - PASSENGER CREW DOOR (98D52103501000), (Ref. TASK 52-10-00-480-001).
(4) Remove the door insulation.
**ON A/C ALL
4. Procedure
_________
Subtask 52-13-00-110-050
A. Cleaning
(1) Clean the ends of the girt bar with a brush and CLEANING AGENTS (Material No. 11-004).
(2) Clean the window of the door (Ref. TASK 56-21-13-100-002).
Subtask 52-13-00-916-050
B. Application of Temporary Protection CAUTION : DO NOT APPLY STORAGE PRESERVATION ON THE DOOR CONTROL
_______ MECHANISMS. THIS IS BECAUSE STORAGE PRESERVATION CAN PREVENT CORRECT OPERATION OF THE MECHANISMS.
1EFF : ALL 1 52-13-00Page 304 1 1 Aug 01/05 1 1 1CES 1
(1) Apply a layer of STORAGE PRESERVATION (Material No. 15-005) or STORAGE PRESERVATION (Material No. 15-006) on all the parts, but not on the mechanisms.
5. Close-up
________
**ON A/C 001-002,
Subtask 52-13-00-410-060
A. Installation of the Components
(1)
Install the door insulation.
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM DOORS 艙門2(56)
