-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
Material No. 11-026 GB DEF-STAN 68-148/1
SOLVENT GENERAL PURPOSE (Ref. 20-31-00)
Material No. 19-003 USA AMS 3819
LINT-FREE COTTON CLOTH (Ref. 20-31-00)
C. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
27-50-00-866-008 Extension of the Flaps on the Ground 27-50-00-866-009 Retraction of the Flaps on the Ground 32-00-00-481-001 Installation of the Safety Devices on the Landing
Gears
ASRM 575100 (for corrective action)
57-51-00-991-015 Fig. 614
3. Job Set-up
__________
Subtask 57-51-00-941-064
A. Safety Precautions
R (1) Make sure that the safety devices are on the MLG (Ref. TASK 32-00-00-481-001).
(2)
Put warning notices in position to tell persons not to operate the landing gear.
(3)
Put warning notices in the cockpit to tell persons not to operate the flaps or slats.
(4)
Put the safety barriers in position.
R 1EFF : 001-049, 051-099, 101-105, 151-159, 1 57-51-00Page 683 1201-210, 1May 01/05 1 1 1CES 1
Subtask 57-51-00-860-058
B. Aircraft Maintenance Configuration WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROLS ARE
_______ CLEAR. MOVEMENT OF FLIGHT CONTROLS CAN CAUSE INJURY TO PERSONS AND/OR DAMAGE.
(1)
Fully extend the flaps (Ref. TASK 27-50-00-866-008).
(2)
Make sure that the LOCKING TOOL - FLAP/SLAT CONTROL LEVER is installed on the flap/slat control lever.
R **ON A/C 001-049, 051-061, 101-103, 201-203,
Subtask 57-51-00-010-083
C. Get Access
(1)
Put the access platform below the applicable wing trailing edge at the MLG support RIB5, zone 570(670).
(2)
Open the applicable access panel:
-for the left wing, open 574AB
-for the right wing, open 674AB. R **ON A/C 062-099, 104-105, 151-159, 204-210,
Subtask 57-51-00-010-083-A
C. Get Access
(1)
Put the access platform below the applicable wing trailing edge at the MLG support RIB5, zone 570(670).
(2)
Remove the applicable access panel:
-
for the left wing, remove 574AB
-
for the right wing, remove 674AB.
R 1EFF : 001-049, 051-099, 101-105, 151-159, 1 57-51-00Page 684 1201-210, 1May 01/05 1 1 1CES 1
R **ON A/C 001-049, 051-099, 101-105, 151-159, 201-210,
Subtask 57-51-00-865-077
D. Make sure that this(these) circuit breaker(s) is(are) open, safetied and tagged
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU FLIGHT CONTROLS/FLP/CTL AND MONG/SYS1 6CV B07 121VU FLIGHT CONTROLS/FLP/CTL AND/MONG/SYS2 8CV Q21
4. Procedure
_________
(Ref. Fig. 614/TASK 57-51-00-991-015)
CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING
_______
EDGE:
-
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.
-
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS.
-MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY. INCORRECT INSTALLATION CAN CAUSE DAMAGE.
Subtask 57-51-00-110-086
A. Preparation for Inspection
(1) Use a MISCELLANEOUS (Material No. 19-003), made moist with CLEANING AGENTS (Material No. 11-026) to clean the inboard and outboard faces of the outer wing MLG support RIB5.
Subtask 57-51-00-210-055
B. Inspection
(1) Use a flashlight and a mirror to examine the inboard and outboard faces of the outer wing MLG support RIB5. Make sure that:
-
there are no cracks
-
there is no damage
-
there is no corrosion
-the protective finish is in the correct condition.
NOTE : If necessary, refer to the ASRM (Ref. ASRM 575100) for the
____
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM WINGS 機翼3(100)
