C. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
27-80-00-866-004 Extending the Slats on the Ground 27-80-00-866-005 Retracting the Slats on the Ground ASRM 574000 (for corrective action) 57-44-00-991-008 Fig. 602
3. Job Set-up
__________ Subtask 57-44-00-941-054
A. Safety Precautions
(1)
Put warning notices in the cockpit to tell persons not to operate the flaps or slats.
(2)
Put the safety barriers in position.
(3)
Put the adjustable access platform below the applicable wing leading edge at slat 3, zone 522(622).
Subtask 57-44-00-860-054
B. Aircraft Maintenance Configuration
(1)
Extend the slats fully (Ref. TASK 27-80-00-866-004).
(2)
Install the LOCKING TOOL - FLAP/SLAT CONTROL LEVER (98D27803000000) on the flap/slat control lever.
Subtask 57-44-00-865-058
C. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU FLIGHT CONTROLS/SLT/CTL AND MONG/SYS1 5CV B06 121VU FLIGHT CONTROLS/SLT/CTL/SYS2 7CV R21
4. Procedure_________
(Ref. Fig. 602/TASK 57-44-00-991-008)
Subtask 57-44-00-110-057
R R A. Preparation for Inspection
R R (1) Use a MISCELLANEOUS (Material No. 19-003), made moist with CLEANING AGENTS (Material No. 11-026) to clean the Slat 3 skin connections in the area of the lower girder at track ribs 7 and 8.
Subtask 57-44-00-210-054
B. Inspection
(1) Visually examine the slat 3 skin connections in the area of the lower girder at track ribs 7 and 8. Make sure that: - there are no cracks - there is no corrosion - there is no damage - the surface protection is in the correct condition.
NOTE : If necessary, refer to the ASRM (Ref. ASRM 574000) for the____ correct repair procedure.
5. Close-up________
Subtask 57-44-00-865-059
A. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s): 5CV, 7CV.
Subtask 57-44-00-860-055
B. Aircraft Configuration
(1) Retract the slats fully (Ref. TASK 27-80-00-866-005).
Subtask 57-44-00-942-059
C. Removal of Equipment
(1)
Remove the warning notice(s).
(2)
Make sure that the work area is clean and clear of tool(s) and other items.
(3)
Remove the access platform(s).
(4)
Remove the safety barriers.
(5)
Remove the ground support and maintenance equipment, the special and standard tools and all other items.
1EFF : ALL 1 57-44-00Page 609 1 1 Nov 01/04R 1 1 1CES 1
Details of the Slat 3 Skin Connection in the area of the Lower Girder (Track
Ribs 7 and 8)
Figure 602/TASK 57-44-00-991-008- 12 (SHEET 1)
Details of the Slat 3 Skin Connection in the area of the Lower Girder (Track
Ribs 7 and 8)
Figure 602/TASK 57-44-00-991-008- 22 (SHEET 2)
TASK 57-44-00-200-008
Special Detailed Inspection of the Slat 3 Skin Connection in Area of Lower Girder at Track Rib Stations, LH/RH
WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM WINGS 機翼3(47)
