-MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY. INCORRECT INSTALLATION CAN CAUSE DAMAGE.
 1. Reason for the Job
__________________
 Refer to the MPD TASK: 575140-01
 2. Job Set-up Information
______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific flashlight No specific mirror No specific safety barriers No specific warning notices No specific access platform 1.5 m (4 ft. 11 in.)
R 1EFF : ALL 1 57-51-00Page 664 1 1 May 01/04 1 1 1CES 1

 B. Consumable Materials

 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
Material No. 11-026 GB DEF-STAN 68-148/1
 SOLVENT GENERAL PURPOSE (Ref. 20-31-00)
 Material No. 19-003 USA AMS 3819
 LINT-FREE COTTON CLOTH (Ref. 20-31-00)

 C. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
27-50-00-866-008 Extension of the Flaps on the Ground 27-50-00-866-009 Retraction of the Flaps on the Ground 32-00-00-481-001 Installation of the Safety Devices on the Landing
 Gears
 32-12-00-010-001 Open the Main Gear Doors for Access
 32-12-00-410-001 Close the Main Gear Doors after Access
 53-35-11-000-001 Removal of the Wing-to-Fuselage Fairings
 53-35-11-400-001 Installation of the Wing-to-Fuselage Fairings
 ASRM 575100 (for corrective action)

 **ON A/C 001-049, 051-061, 101-103, 201-203, 301-399,
 57-51-00-991-013 Fig. 612
R **ON A/C 062-099, 104-149, 151-199, 204-299, 401-499,
 57-51-00-991-013-A Fig. 612A

 **ON A/C ALL

 3. Job Set-up
__________ Subtask 57-51-00-941-063
 A. Safety Precautions
 (1)
 Make sure that the safety devices are on the MLG (Ref. TASK 32-00-00-481-001).

 (2)
 Put warning notices in position to tell persons not to operate the landing gear or the landing gear doors.

 (3)
 Put warning notices in the cockpit to tell persons not to operate the flaps or slats.

 (4) Put the safety barriers in position. Subtask 57-51-00-860-054
 B. Aircraft Maintenance Configuration
 (1)
 Fully extend the flaps (Ref. TASK 27-50-00-866-008).

 (2)
 Make sure that the LOCKING TOOL - FLAP/SLAT CONTROL LEVER is installed on the flap/slat control lever.

 Subtask 57-51-00-865-073
 C. Make sure that this(these) circuit breaker(s) is(are) open, safetied and tagged
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU FLIGHT CONTROLS/FLP/CTL AND MONG/SYS1 6CV B07 121VU FLIGHT CONTROLS/FLP/CTL AND/MONG/SYS2 8CV Q21
 1EFF : ALL 1 57-51-00Page 666 1 1 May 01/04R 1 1 1CES 1

 Subtask 57-51-00-010-063

 D. Get Access
 (1)
 Open the applicable MLG doors (Ref. TASK 32-12-00-010-001).

 (2)
 Make sure that the GROUND LOCK SLEEVE is on the applicable MLG door actuating cylinder.

 (3)
 Put the access platform in position below the applicable MLG bay, zone 734(744).

 (4)
 Remove the applicable access panels (Ref. TASK 53-35-11-000-001):

 -
for the left wing, remove 191ET, 193AT

 -
for the right wing, remove 192ET, 194AT.

 4. Procedure
_________
 **ON A/C 001-049, 051-061, 101-103, 201-203, 301-399,

 (Ref. Fig. 612/TASK 57-51-00-991-013) R **ON A/C 062-099, 104-149, 151-199, 204-299, 401-499,
 (Ref. Fig. 612A/TASK 57-51-00-991-013-A)
 **ON A/C ALL

 CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING
_______
 EDGE:

 -
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.

 -
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS.

 -MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY. INCORRECT INSTALLATION CAN CAUSE DAMAGE.
 Subtask 57-51-00-110-063
 A. Preparation for Inspection
 (1) Use a MISCELLANEOUS (Material No. 19-003), made moist with CLEANING AGENTS (Material No. 11-026) to clean the items to be inspected.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM WINGS 機翼3(96)