(2)
Extend the flaps (Ref. TASK 27-50-00-866-008).
(3)
Make sure that the LOCKING TOOL - FLAP/SLAT CONTROL LEVER is installed on the flap/slat control lever.
1EFF : ALL 1 57-51-00Page 659 1 1 May 01/04R 1 1 1CES 1
(4)
Make sure that the COLLAR-SAFETY, SPOILER is installed on the spoiler
actuator.
(5)
Put the adjustable access platform below the applicable wing trailing edge at spoilers 2, 3, 4 and 5, zones 570(670) and 580(680).
Subtask 57-51-00-865-070
C. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU FLIGHT CONTROLS/FLP/CTL AND MONG/SYS1 6CV B07 121VU FLIGHT CONTROLS/FLP/CTL AND/MONG/SYS2 8CV Q21 121VU FLIGHT CONTROLS/SEC3/SPLY 21CE3 Q19 121VU FLIGHT CONTROLS/SEC2/SPLY 21CE2 Q18
4. Procedure
_________
(Ref. Fig. 611/TASK 57-51-00-991-012)
CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING
_______
EDGE:
-
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.
-
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS.
-MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY. INCORRECT INSTALLATION CAN CAUSE DAMAGE.
Subtask 57-51-00-110-062
A. Preparation for Inspection
(1) Use a MISCELLANEOUS (Material No. 19-003), made moist with CLEANING AGENTS (Material No. 11-026) to clean the actuator hinge-fittings on spoilers 2 thru 5.
1EFF : ALL 1 57-51-00Page 660 1 1 May 01/04R 1 1 1CES 1
Spoiler 2 to 5 Actuator and Hinge Fittings Figure 611/TASK 57-51-00-991-012
1EFF : 1 1R 1CES ALL 1 11 1 57-51-00 Page 661 May 01/04
Subtask 57-51-00-280-051
B. Inspection
(1) Do a special detailed inspection of the spoilers 2 thru 5 actuator and hinge-fittings (Ref. NTM 57-51-07 PART 6).
NOTE : If necessary, refer to the ASRM (Ref. ASRM 575100) for the
____ correct repair procedure. If the defect is not included in this repair, you must request a procedure from Airbus Industrie. ________
5. Close-up
Subtask 57-51-00-865-071
A. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s): 6CV, 8CV, 21CE2, 21CE3.
Subtask 57-51-00-860-074
B. Aircraft Maintenance Configuration
(1)
Make sure that the work area is clean and clear of tool(s) and other items.
(2)
Remove the COLLAR-SAFETY, SPOILER from the spoiler actuator.
(3)
Retract the spoilers (Ref. TASK 27-60-00-866-002).
(4)
Remove the LOCKING TOOL - FLAP/SLAT CONTROL LEVER from the flap/slat control lever.
(5) Retract the flaps (Ref. TASK 27-50-00-866-009). Subtask 57-51-00-942-069
C. Removal of Equipment
(1)
Remove the access platform(s).
(2)
Remove the warning notice(s).
(3)
Remove the safety barriers.
1EFF : ALL 1 57-51-00Page 662 1 1 May 01/04R 1 1 1CES 1
(4) Remove the ground support and maintenance equipment, the special and
standard tools and all other items.
1EFF : ALL 1 57-51-00Page 663 1 1 May 01/04R 1 1 1CES 1
TASK 57-51-00-200-003
Detailed Visual Inspection of Flap Track 1, including Attachment Brackets to Fuselage, Strut, Carriage and Swinging Link (Pendulum) LH/RH
WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______ START A TASK ON OR NEAR:
-
THE FLIGHT CONTROLS
-
THE FLIGHT CONTROL SURFACES
-
THE LANDING GEAR AND THE RELATED DOORS
-COMPONENTS THAT MOVE.
WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______ GEAR.
CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING EDGE:
_______
-
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.
-
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS.
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM WINGS 機翼3(95)
