(2)
Remove the applicable flap track fairings (Ref. TASK 57-55-11-000-001):
-
for the left wing, remove 531CB, 532CB, 533CB
-
for the right wing, remove 631CB, 632CB, 633CB.
**ON A/C 301-399,
Subtask 57-51-00-010-055-A
C. Get Access
(1)
Put the adjustable access platform in position below the applicable wing trailing edge at the flap.
(2)
Remove the applicable flap track fairings (Ref. TASK 57-55-11-000-004):
-
for the left wing, remove 531CB, 532CB, 533CB
-
for the right wing, remove 631CB, 632CB, 633CB.
R **ON A/C ALL
4. Procedure
_________ (Ref. Fig. 608/TASK 57-51-00-991-007) CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING
_______
EDGE:
-
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.
-
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS.
-MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY. INCORRECT INSTALLATION CAN CAUSE DAMAGE.
Subtask 57-51-00-110-057
A. Preparation for Inspection
(1) Use a MISCELLANEOUS (Material No. 19-003), made moist with CLEANING AGENTS (Material No. 11-026) to clean the flap actuator brackets at tracks 2, 3 and 4.
Subtask 57-51-00-270-050
B. Inspection
(1) Do a special detailed inspection of the flap actuator brackets at tracks 2, 3 and 4 (Ref. NTM 57-51-01 PART 4).
NOTE : If necessary, refer to the ASRM (Ref. ASRM 575100) for the
____ correct repair procedure. If the defect is not included in this repair, you must request a procedure from Airbus Industrie.
Flap Acuator Brackets Figure 608/TASK 57-51-00-991-007
1EFF : 1 1R 1CES ALL 1 11 1 57-51-00 Page 645 May 01/04
5. Close-up
________
R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,
Subtask 57-51-00-410-056
A. Close Access
(1)
Make sure that the work area is clean and clear of tool(s) and other items.
(2)
Install the applicable flap track fairings (Ref. TASK 57-55-11-400-001):
-
for the left wing, install 531CB, 532CB, 533CB
-
for the right wing, install 631CB, 632CB, 633CB.
(3)
Remove the LOCKING TOOL - FLAP/SLAT CONTROL LEVER from the flap/slat control lever.
(4) Fully retract the flaps (Ref. TASK 27-50-00-866-009).
**ON A/C 301-399,
Subtask 57-51-00-410-056-A
A. Close Access
(1)
Make sure that the work area is clean and clear of tool(s) and other items.
(2)
Install the applicable flap track fairings (Ref. TASK 57-55-11-400-004):
-
for the left wing, install 531CB, 532CB, 533CB
-
for the right wing, install 631CB, 632CB, 633CB.
(3)
Remove the LOCKING TOOL - FLAP/SLAT CONTROL LEVER from the flap/slat control lever.
(4)
Fully retract the flaps (Ref. TASK 27-50-00-866-009).
R **ON A/C ALL
Subtask 57-51-00-865-061
B. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s): 6CV, 8CV.
Subtask 57-51-00-942-056
C. Removal of Equipment
(1)
Remove the warning notice(s).
(2)
Remove the access platform(s).
(3)
Remove the safety barriers.
(4)
Remove the ground support and maintenance equipment, the special and standard tools and all other items.
TASK 57-51-00-220-006
Detailed Visual Inspection of Outer Wing Trailing Edge Spoiler 1 Actuator and Hinge-Fittings
WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______ START A TASK ON OR NEAR:
-
THE FLIGHT CONTROLS
-
THE FLIGHT CONTROL SURFACES
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM WINGS 機翼3(91)
