57-51-09 20 -350 57-51-09 20 -39057-51-33 13 -19057-51-05 74 -070 57-51-09 20 -30057-51-05 74 -070
R 1EFF : ALL 1 57-51-33Page 412 1 1 May 01/04 1 1 1CES 1
D. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
27-54-49-000-001 Removal of the Flap Track 1 Actuator 6205CM(6255CM) 27-54-49-400-001 Installation of the Flap Track 1 Actuator
6205CM(6255CM)
27-54-61-000-001 Removal of the Inboard Flap
27-54-61-000-003 Removal of the Inboard Double-Slotted Flap
27-54-61-400-001 Installation of the Inboard Flap
27-54-61-400-003 Installation of the Inboard Double-Slotted Flap
57-51-15-400-001 Installation of the Shroud Box 572(672)
SRM 514211
**ON A/C 001-049, 051-061, 101-103, 201-203,
57-51-33-991-001 Fig. 401
R **ON A/C 062-099, 104-149, 151-199, 204-299, 401-499,
57-51-33-991-001-A Fig. 401A
**ON A/C 301-399,
57-51-33-991-001-B Fig. 401B
**ON A/C ALL
3. Job Set-up
__________
Subtask 57-51-33-941-054
A. Safety Precautions
(1)
Make sure that the warning notices are in position in the cockpit to tell persons not to operate the flaps or slats.
(2)
Make sure that the safety barriers are in position.
R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,
Subtask 57-51-33-860-050
B. Aircraft Maintenance Configuration
(1)
Make sure that the LOCKING TOOL - FLAP/SLAT CONTROL LEVER (98D27803000000) is installed on the flap/slat control lever.
(2)
Make sure that the inboard flap (1) has been removed (Ref. TASK 27-54-61-000-001).
(3)
Make sure that the No.1 flap track actuator has been removed (Ref. TASK 27-54-49-000-001).
(4)
Make sure that the access platform is in position below the No.1 flap track beam, zone 581 (681).
**ON A/C 301-399,
Subtask 57-51-33-860-050-A
B. Aircraft Maintenance Configuration
(1)
Make sure that the LOCKING TOOL - FLAP/SLAT CONTROL LEVER (98D27803000000) is installed on the flap/slat control lever.
(2)
Make sure that the inboard flap (1) has been removed (Ref. TASK 27-54-61-000-003).
(3)
Make sure that the No.1 flap track actuator has been removed (Ref. TASK 27-54-49-000-001).
(4)
Make sure that the access platform is in position below the No.1 flap track beam, zone 581 (681).
**ON A/C ALL
Subtask 57-51-33-865-052
C. Make sure that this(these) circuit breaker(s) is(are) open, safetied and tagged
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU FLIGHT CONTROLS/FLP/CTL AND MONG/SYS1 6CV B07 121VU FLIGHT CONTROLS/FLP/CTL AND/MONG/SYS2 8CV Q21
4. Procedure
_________
**ON A/C 001-049, 051-061, 101-103, 201-203,
(Ref. Fig. 401/TASK 57-51-33-991-001)
R **ON A/C 062-099, 104-149, 151-199, 204-299, 401-499,
(Ref. Fig. 401A/TASK 57-51-33-991-001-A)
**ON A/C 301-399,
(Ref. Fig. 401B/TASK 57-51-33-991-001-B)
**ON A/C ALL
CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING
_______
EDGE:
-
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS.
-
DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS.
-MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY. INCORRECT INSTALLATION CAN CAUSE DAMAGE.
R **ON A/C 001-049, 051-061, 101-103, 201-203,
Subtask 57-51-33-420-067
A. Preparation for Installation
WARNING : USE SOLVENTS/CLEANING AGENTS, SEALANTS AND OTHER SPECIAL
_______ MATERIALS ONLY WITH A GOOD SUPPLY OF AIR. OBEY THE MANUFACTURERS INSTRUCTIONS. PUT ON PROTECTIVE CLOTHING. DO NOT GET THEM IN YOUR MOUTH. DO NOT SMOKE. DO NOT BREATHE THE GAS. THESE MATERIALS ARE POISONOUS, FLAMMABLE AND SKIN IRRITANT. GET MEDICAL HELP IF YOUR SKIN OR EYES BECOME IRRITATED.
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM WINGS 機翼3(138)
