C. Referenced Information
 -------------------------------------------------------------------------------
REFERENCE  DESIGNATION
 -------------------------------------------------------------------------------
27-80-00-866-004 Extending the Slats on the Ground
 27-80-00-866-005 Retracting the Slats on the Ground
R  27-84-67-000-001 Removal of the No. 5 Slat
R  27-84-67-400-002 Installation of the No. 5 Slat ASRM 574000 (for corrective action) 57-46-00-991-009 Fig. 605 57-46-00-991-010 Fig. 606 57-46-00-991-002 Fig. 607 57-46-00-991-003 Fig. 608
 3. Job Set-up
__________
 Subtask 57-46-00-941-057
 A. Safety Precautions
 (1)
 Put warning notices in the cockpit to tell persons not to operate the flaps or slats.

 (2)
 Put the safety barriers in position.

 Subtask 57-46-00-860-058
 B. Aircraft Maintenance Configuration
 (1)
 Fully extend the slats (Ref. TASK 27-80-00-866-004).

 (2)
 Make sure that the LOCKING TOOL - FLAP/SLAT CONTROL LEVER is installed on the flap/slat control lever.

 Subtask 57-46-00-865-064
 C. Open, safety and tag this(these) circuit breaker(s):
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU FLIGHT CONTROLS/SLT/CTL AND MONG/SYS1 5CV B06 121VU FLIGHT CONTROLS/SLT/CTL/SYS2 7CV R21

 Subtask 57-46-00-010-056
 D. Get Access
 (1) Put the adjustable access platform in position below the applicable wing leading edge at slat 5, zone 515(615).
 4. Procedure
_________ (Ref. Fig. 605/TASK 57-46-00-991-009, 606/TASK 57-46-00-991-010, 607/TASK 57-46-00-991-002, 608/TASK 57-46-00-991-003) Subtask 57-46-00-110-060
 A. Preparation for Inspection
 (1)
 Use a MISCELLANEOUS (Material No. 19-003), made moist with CLEANING AGENTS (Material No. 11-026) to clean the inspection area of slat track 11 shown.

 (2)
 Use a MISCELLANEOUS (Material No. 19-003), made moist with CLEANING AGENTS (Material No. 11-026) to clean the inspection area of slat track 12 shown.

R **ON A/C 001-049, 051-099, 101-105, 151-199, 201-227,
 Subtask 57-46-00-210-055
 B. Inspection
 (1) Examine the slat 5, tracks 11 and 12 attachment links, side plates, track rib lugs and track lugs. Make sure that:
 -there is no corrosion, cracks or damage
 -the sealant is in a serviceable condition.
 NOTE : If necessary, refer to the ASRM (Ref. ASRM 574000) for the

____
 correct repair procedure.

 (2) Examine each slat attachment bolt on slat tracks 11 or 12 as follows: NOTE : Remove one of the attachment bolts, examine it and install it
____ correctly before removing a different bolt for inspection. Do not remove more than one attachment bolt at any time.
 (a) Remove one of the slat attachment bolts on tracks 11 or 12 (Ref. TASK 27-84-67-000-001).

R R  Slat 5, Track 11 - Inspection Details Figure 605/TASK 57-46-00-991-009
 1EFF : 1 1 1CES  ALL  1 111 57-46-00 Page 626 May 01/98

R R  Slat 5, Track 12 - Inspection Details Figure 606/TASK 57-46-00-991-010
 1EFF : 1 1 1CES  ALL  1 111 57-46-00 Page 627 May 01/98

 Details of the Slat Track 11 Link Sideplates and Bolts
 Figure 607/TASK 57-46-00-991-002

 1EFF : ALL 1 57-46-00Page 628 1 1 Nov 01/99R 1 1 1CES 1

 Details of the Slat Track 12 Link Sideplates and Bolts
 Figure 608/TASK 57-46-00-991-003

 1EFF : ALL 1 57-46-00Page 629 1 1 Nov 01/99R 1 1 1CES 1

 (b) Examine the attachment bolt. Make sure that:
 -there is no corrosion or damage
 -
the shank of the bolt is not worn

 -
the bolt hole is not worn or damaged.
 NOTE : If necessary, discard the worn/damaged bolt and install a

____
 replacement item.

 (c)
 Install the slat attachment bolt (Ref. TASK 27-84-67-400-002).

 (d)
 Do steps (a) thru (c) for each attachment bolt on the slat tracks 11 and 12 attachment links and side plates.

R **ON A/C 106-149, 228-299, 301-399, 401-499,
 Subtask 57-46-00-210-055-A
 B. Inspection
 (1)
 Do an inspection of the slat track 11 and 12 attachments in the areas shown.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM WINGS 機翼3(72)