S 712-101
(14)
Verify both the A and B FLT CONTROL LOW PRESSURE lights are off.
S 792-096
(15)
Make sure the manual override lever on the shutoff valve is at position 1.
S 212-090
(16)
Put the FLIGHT CONTROL B switch to the STDBY RUD position and the FLIGHT CONTROL A switch to the OFF position. .
S 712-102
(17)
Verify the A FLT CONTROL LOW PRESSURE light is on.
S 212-091
(18)
Make sure the manual override lever on the shutoff valve is at position 2.
S 792-094
(19)
Make sure there is no hydraulic fluid leakage from the shutoff valve.
S 862-087
(20)
Put both the FLIGHT CONTROL A and FLIGHT CONTROL B switches to the ON position.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
27-21-94
ALL ú ú 01 Page 207 ú Mar 12/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
S 712-103 (21) Verify both the A and B FLT CONTROL LOW PRESSURE lights are off.
S 212-088 (22) Make sure the manual override lever on the shutoff valve is at position 1.
ú ú ú ú ú ú S 792-048 (23) Make sure there is no hydraulic fluid leakage from the shutoff valve.S 862-105(24) Remove hydraulic pressure if it is not needed (AMM 27-21-00/201).S 862-089(25) Remove electrical power if it is not needed (AMM 24-22-00/201).
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
27-21-94
ALL ú ú 01.1 Page 208 ú Jul 12/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
RUDDER HYDRAULIC FUSE - REMOVAL/INSTALLATION
____________________________________________
1. General_______
A. This procedure has two tasks, one for the removal and one for the installation of the hydraulic fuse for the rudder.
TASK 27-21-95-004-001
2. Hydraulic Fuse Removal______________________
A. References
(1)
27-21-00/201, Rudder and Rudder Trim Control System
(2)
29-09-00/201, Hydraulic Reservoir Pressurization System
B.
Access
(1)
Location Zone
701 Tail Compartment
(2)
Access Panels
3701 Stabilizer Trim Access Door
C.
Procedure
S 864-002
(1)
Remove the rudder hydraulic power system B (Ref 27-21-00/201).
S 864-018
(2)
Release the pressure from the system B hydraulic reservoir (Ref 29-09-00/201).
S 864-020
(3)
Open these circuit breakers and attach DO-NOT-CLOSE tags:
(a)
P6-2 panel
1) STABILIZER TRIM ACTUATOR
2) STABILIZER TRIM CONT
(4)
Get access to the tail compartment through access door 3701.
S 864-019
(5)
Close the No. 5 manual shutoff valve (hydraulic system B) (Fig. 401).
S 024-003
(6)
Do these steps to remove the hydraulic fuse (Fig. 401):
(a)
Disconnect the hydraulic lines from the fuse.
(b)
Remove the hydraulic fuse.
S 014-021
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH A RUDDER HYDRAULIC FUSE ú
27-21-95
(FOR HYDRAULIC SYSTEM B) ú ú 01 Page 401 ú Nov 15/91
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
TAIL COMPARTMENT SEE A
HYDRAULIC FUSE FOR THE RUDDER
NO. 5 MANUAL
SHUTOFF VALVE
FWD
TAIL COMPARTMENT A
Rudder Hydraulic Fuse Installation
Figure 401
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH A RUDDER HYDRAULIC FUSE ú 中國航空網 www.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 飛行操縱 FLIGHT CONTROLS 2(81)
