曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

R A. Aircraft Maintenance Configuration
R (1) Put the SAFETY BARRIERS in position.
R (2) Put a WARNING NOTICE in position to tell persons not to operate the R landing gear doors.
R (3) Make sure that: R - The fuel quantity in the wing tanks are symetrical or the wing R tanks are empty R - Two engines are installed R - The weight of the aircraft is on the landing gear (weight on the R wheels).
R (4) Extension of the flaps

R WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROLS ARE
_______ R CLEAR. MOVEMENT OF FLIGHT CONTROLS CAN CAUSE INJURY TO R PERSONS AND/OR DAMAGE.
R (a) Extend the flaps fully (Ref. TASK 27-50-00-866-008).

R  (b) Install the LOCKING TOOL - FLAP/SLAT CONTROL LEVER on the 
R  flap/slat control lever on panel 114VU. 
R  Subtask 27-54-00-865-080 
R  B. Open, safety and tag this(these) circuit breaker(s): 
R  -------------------------------------------------------------------------------
R  PANEL DESIGNATION IDENT. LOCATION 
R  -------------------------------------------------------------------------------
R  49VU AUTO FLT/FAC1/28VDC 5CC1 B04 
R  49VU AUTO FLT/FAC1/26VAC 14CC1 B03 
R  121VU AUTO FLT/RUDDER/TRIM/IND 15CC M20 
R  121VU AUTO FLT/FAC2/28VDC 5CC2 M19 
R  121VU AUTO FLT/FAC2/26VAC 14CC2 M18 
R  Subtask 27-54-00-010-067 
R  C. Get Access 
R  (1) Open the main gear doors (Ref. TASK 32-12-00-010-001). 
R  (2) Install the GROUND LOCK SLEEVE on the applicable main gear 
R  door-actuator (Ref. TASK 32-00-00-481-002). 
R  (3) Put the ACCESS PLATFORM 3M (10 FT)- ADJUSTABLE in position. 
R  (4) Remove the applicable access panels (Ref. TASK 57-51-37-000-002) and 
R  (Ref. TASK 57-51-37-000-004): 
R  For the LH wing, remove the panels: 
R  - 571AB 
R  - 573AB, 573BB, 573CB 
R  - 575AB, 575BB, 575CB, 575DB, 575EB, 575FB and 575FB. 
R  For the RH wing, remove the panels: 
R  - 671AB 
R  - 673AB, 673BB, 673CB 
R  - 675AB, 675BB, 675CB, 675DB, 675EB, 675FB and 675FB. 
R  (5) Clean the rigging pin holes at the track 1, 2, 3 and 4. 
R  (6) Remove the LOCKING TOOL - FLAP/SLAT CONTROL LEVER on the flap/slat 
R  control lever on panel 114VU.

 

R  Subtask 27-54-00-865-081 
R  D. Make sure that this(these) circuit breaker(s) is(are) closed: 
R  -------------------------------------------------------------------------------
R  PANEL DESIGNATION IDENT. LOCATION 
R  -------------------------------------------------------------------------------
R  49VU AUTO FLT/FAC1/28VDC 5CC1 B04 
R  49VU AUTO FLT/FAC1/26VAC 14CC1 B03 
R  121VU AUTO FLT/RUDDER/TRIM/IND 15CC M20 
R  121VU AUTO FLT/FAC2/28VDC 5CC2 M19 
R  121VU AUTO FLT/FAC2/26VAC 14CC2 M18 
R  Subtask 27-54-00-866-060 
R  E. Retraction of the flaps 
R  (1) Retract the flaps fully (Ref. TASK 27-50-00-866-009). Do not do this 
R  not manually. 
R  (2) Install the LOCKING TOOL - FLAP/SLAT CONTROL LEVER on the flap/slat 
R  control lever on panel 114VU. 
R  (3) Put a WARNING NOTICE on panel 114VU to tell persons not to operate 
R  the flap/slat controls. 
R  Subtask 27-54-00-865-082 
R  F. Open, safety and tag this(these) circuit breaker(s): 
R  -------------------------------------------------------------------------------
R  PANEL DESIGNATION IDENT. LOCATION 
R  -------------------------------------------------------------------------------
R  49VU AUTO FLT/FAC1/28VDC 5CC1 B04 
R  49VU AUTO FLT/FAC1/26VAC 14CC1 B03 
R  121VU AUTO FLT/RUDDER/TRIM/IND 15CC M20 
R  121VU AUTO FLT/FAC2/28VDC 5CC2 M19 
R  121VU AUTO FLT/FAC2/26VAC 14CC2 M18 
R  4. Procedure_________ 
R  CAUTION : BE CAREFUL WHEN YOU DO MAINTENANCE TASKS ON THE WING TRAILING_______ 
R  EDGE: 
R  - DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE RACEWAYS. 
R  - DO NOT CAUSE DAMAGE TO THE ELECTRICAL CABLE INSTALLATIONS. 
R  - MAKE SURE THAT THE ELECTRICAL CABLES ARE INSTALLED CORRECTLY. 
R  INCORRECT INSTALLATION CAN CAUSE DAMAGE.

 

R  Subtask 27-54-00-820-051 
R  A. Adjustment of the Flap Track No. 1 
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FLIGHT CONTROLS 飛行操縱4(151)