B. Consumable Materials
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
Material No. 15-007 AIB TN 10138 TYPE II GRADE 1 CORROSION PREVENTIVE TEMPORARY PROTECTIVE COMPOUND (Ref. 20-31-00)
C. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
27-00-00-080-002 Removal of the Flap/Slat Control-Lever Locking Tool
(98D27803000000) 27-50-00-866-008 Extension of the Flaps on the Ground 27-50-00-866-009 Retraction of the Flaps on the Ground 32-00-00-481-001 Installation of the Safety Devices on the Landing
Gears
32-12-00-010-001 Open the Main Gear Doors for Access
32-12-00-410-001 Close the Main Gear Doors after Access
57-51-37-000-002 Removal of the Access Panels 573AB(673AB),
573BB(673BB), 573CB(673CB)
57-51-37-000-004 Removal of the Access Panels 575AB/575BB/575CB/575DB/575EB/575FB/575GB/575HB (675AB/675BB/675CB/675DB/675EB/675FB/675GB/675HB)
57-51-37-400-002 Installation of the Access Panels 573AB(673AB),
573BB(673BB), 573CB(673CB)
57-51-37-400-004 Installation of the Access Panels 575AB/575BB/575CB/575DB/575EB/575FB/575GB/ 575HB (675AB/675BB/675CB/675DB/675EB/675FB/675GB/675HB)
27-54-00-991-006 Fig. 601
R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,
27-54-00-991-001 Fig. 602
**ON A/C 301-399,
27-54-00-991-001-A Fig. 602A -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,
27-54-00-991-002 Fig. 603
**ON A/C 301-399,
27-54-00-991-002-A Fig. 603A
**ON A/C ALL
3. Job Set-up
__________
(Ref. Fig. 601/TASK 27-54-00-991-006)
Subtask 27-54-00-941-052
A. Safety Precautions
(1)
Make sure that the ground safety locks are installed on the landing gear (Ref. TASK 32-00-00-481-001).
(2)
Put the warning notice in position to tell persons not to pressurize the hydraulic systems.
(3)
Put a warning notice in position to tell persons not to operate the flight controls.
(4)
Put a warning notice in position to tell persons not to operate the landing gear doors.
(5) Put the safety barriers in position.
Subtask 27-54-00-860-059
B. Aircraft Maintenance Configuration WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROLS ARE
_______ CLEAR. MOVEMENT OF FLIGHT CONTROLS CAN CAUSE INJURY TO PERSONS AND/OR DAMAGE.
Flap Transmission - Access Panels Figure 601/TASK 27-54-00-991-006
1EFF : 1 1R 1CES ALL 1 11 1 27-54-00 Page 604 Aug 01/02
(1)
Extend the flaps fully (Ref. TASK 27-50-00-866-008).
(2)
Make sure that the LOCKING TOOL - FLAP/SLAT CONTROL LEVER is installed on the flap/slat control lever.
Subtask 27-54-00-865-053
C. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU FLIGHT CONTROLS/FLP/CTL AND MONG/SYS1 6CV B07 121VU FLIGHT CONTROLS/FLP/CTL AND/MONG/SYS2 8CV Q21
Subtask 27-54-00-010-051
D. Get Access
(1)
Put the adjustable access platform in position below the applicable wing.
(2)
Open the MLG doors (Ref. TASK 32-12-00-010-001).
(3)
Make sure that the GROUND LOCK SLEEVE is installed on each MLG door actuating cylinder.
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FLIGHT CONTROLS 飛行操縱4(158)
