1EFF : ALL 1 28-25-53Page 408 1 1 Feb 01/98 1 1 1CES 1

 FLOODLIGHT - REFUEL/DEFUEL CONTROL PANEL (32QU) - REMOVAL/INSTALLATION
______________________________________________________________________ TASK 28-25-54-000-001 Removal of the Floodlight 32QU WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______ START A TASK ON OR NEAR:
 -
THE FLIGHT CONTROLS

 -
THE FLIGHT CONTROL SURFACES

 -
THE LANDING GEAR AND THE RELATED DOORS

 -COMPONENTS THAT MOVE. WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______ GEAR.
 1.
 Reason for the Job

__________________
 Self Explanatory

 2.
 Job Set-up Information

______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific circuit breaker(s) safety clip(s) No specific safety barriers
 B. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
28-25-54-991-001 Fig. 401
 1EFF : ALL 1 28-25-54Page 401 1 1 Feb 01/98 1 1 1CES 1

 3. Job Set-up
__________
 (Ref. Fig. 401/TASK 28-25-54-991-001)
 Subtask 28-25-54-941-052

 A. Safety Precautions
 (1) Put the safety barriers in position.
 Subtask 28-25-54-010-050

 B. Get Access R (1) Open the access door 192MB. R NOTE : Do not keep the door open longer than necessary because the
____ R battery can discharge.
 Subtask 28-25-54-865-050
 C. Open, safety and tag this(these) circuit breaker(s):
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------122VU ELEC/REFLNG/NORM 2PR S27 122VU ELEC/REFLNG/ON/BAT 1PR U28
 4. Procedure
_________
 (Ref. Fig. 401/TASK 28-25-54-991-001)
 Subtask 28-25-54-020-050

 A. Removal of the Floodlight 32QU
 (1)
 Remove the cable-tie that holds the electrical cables and the cap (1) in position.

 (2)
 Remove the cap (1) from the lamp (6).

 (3)
 Disconnect the electrical wires from the lamp (6).

 (4)
 Remove the screws (4).

 (5)
 Carefully remove the lamp holder (3) together with the lamp (6) from the bracket (2).

 1EFF : ALL 1 28-25-54Page 402 1 1 May 01/98 1 1 1CES 1

 Floodlight 32QU
 Figure 401/TASK 28-25-54-991-001
 1EFF :  ALL  1  28-25-54 Page 403 
1  1  Feb 01/98
 1  1
 1CES  1

 (6)
 Remove the lamp holder (3) together with the lamp (6) from the

 aircraft.

 (7)
 Remove the screws (5) from the lamp holder (3).

 (8)
 Remove the lamp (6) from the lamp holder (3).

 1EFF : ALL 1 28-25-54Page 404 1 1 Feb 01/98 1 1 1CES 1

 TASK 28-25-54-400-001 Installation of the Floodlight 32QU WARNING : MAKE SURE THAT THE FLIGHT CONTROL SAFETY-LOCKS AND THE WARNING
_______ NOTICES ARE IN POSITION.
 WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______ GEAR.
 1.
 Reason for the Job

__________________
 Self Explanatory

 2.
 Job Set-up Information

______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific cable-tie No specific safety barriers
 B. Consumable Materials
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
Material No. 11-004  USA MIL-T-81533 1.1.1TRICHLOROETHANE (METHYL CHLOROFORM) (Ref. 20-31-00)
 Material No. 15-007  AIB TN 10138 TYPE II GRADE 1 CORROSION PREVENTIVE TEMPORARY PROTECTIVE COMPOUND (Ref. 20-31-00)
 Material No. 19-003  USA AMS 3819 LINT-FREE COTTON CLOTH (Ref. 20-31-00)
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FUEL 燃油4(106)