-
THE FLIGHT CONTROL SURFACES
-
THE LANDING GEAR AND THE RELATED DOORS
-COMPONENTS THAT MOVE. WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______ GEAR.
1. Reason for the Job
__________________
Refer to the CDL TASK: 28-1
Refuel / Defuel Coupling Cap
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific safety barriers
No specific access platform 3.5 m (11 ft. 6 in.)
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
28-00-00-910-001 Fuel Safety Procedures 28-25-00-991-023 Fig. 404
1EFF : ALL 1 28-25-00Page 422 1 1 May 01/05R 1 1 1CES 1
3. Job Set-up
__________ Subtask 28-25-00-941-071
A. Safety Precautions
WARNING : OBEY THE FUEL SAFETY PROCEDURES.
_______
(1) You must obey the fuel safety procedures (Ref. TASK 28-00-00-910-001) when you do work on the fuel system.
(2) Put the safety barriers in position. Subtask 28-25-00-010-073
B. Get Access
(1) Put the access platform in position below the applicable
refuel/defuel cap.
4. Procedure
_________
(Ref. Fig. 404/TASK 28-25-00-991-023) Subtask 28-25-00-040-052
A. Deactivation of the Refuel/Defuel Cap
(1)
Release the refuel/defuel cap (4) from the refuel/defuel coupling.
(2)
Examine the refuel/defuel coupling for fuel leaks. No leaks are permitted.
(3)
Remove the screw (1) and the attachment lug (2). NOTE : The chain (3) is spring-loaded into a protection sleeve on the
____
cap (4).
(4)
Remove the refuel/defuel cap (4) and the chain (3) from the refuel/defuel coupling.
(5)
Write in the aircraft technical log that the cap (4) has been removed.
1EFF : ALL 1 28-25-00Page 423 1 1 May 01/05R 1 1 1CES 1
Refuel/Defuel Cap - Left Wing (Right Wing) Figure 404/TASK 28-25-00-991-023
1EFF : 1 1R 1CES ALL 1 11 1 28-25-00 Page 424 May 01/05
5. Close-up
________ Subtask 28-25-00-942-071
A. Removal of Equipment
(1)
Make sure that the work area is clean and clear of tool(s) and other items.
(2)
Remove the safety barriers.
(3)
Remove the warning notice(s).
(4)
Remove the access platform(s).
(5)
Remove the ground support and maintenance equipment, the special and standard tools and all other items.
1EFF : ALL 1 28-25-00Page 425 1 1 May 01/05R 1 1 1CES 1
TASK 28-25-00-440-003 Refuel/Defuel Cap - Reactivation Procedure WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______ START A TASK ON OR NEAR:
-
THE FLIGHT CONTROLS
-
THE FLIGHT CONTROL SURFACES
-
THE LANDING GEAR AND THE RELATED DOORS
-COMPONENTS THAT MOVE. WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______ GEAR.
1. Reason for the Job
__________________
Refer to the CDL TASK: 28-1
Refuel / Defuel Coupling Cap
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific safety barriers
No specific access platform 3.5 m (11 ft. 6 in.)
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
28-00-00-910-001 Fuel Safety Procedures 28-25-41-400-005 Installation of the Refuel/Defuel Coupling/Cap 28-25-00-991-023 Fig. 404
1EFF : ALL 1 28-25-00Page 426 1 1 May 01/05R 1 1 1CES 1
3. Job Set-up
__________ Subtask 28-25-00-941-078
A. Safety Precautions
WARNING : OBEY THE FUEL SAFETY PROCEDURES.
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FUEL 燃油4(44)
