R **ON A/C 003-049, 051-099, 101-149, 151-199, 201-299, 301-399, 401-499,
52-10-00-991-028-A Fig. 601A
52-10-00-991-045 Fig. 602
**ON A/C ALL
3. Job Set-up
__________
Subtask 52-10-00-010-069
A. Get Access
WARNING : DO NOT OPEN THE PASSENGER/CREW DOOR IF THE WIND SPEED IS MORE
_______
THAN 65 KNOTS.
WARNING : BEFORE YOU START WORK ON THE DOOR, MAKE SURE THAT:
_______
-
THE EMERGENCY CONTROL HANDLE IS IN THE DISARMED POSITION WITH THE SAFETY PIN INSTALLED.
-
THE PERCUSSION LEVER OF THE DOOR-DAMPER AND EMERGENCY-OPERATION CYLINDER IS IN THE DISARMED POSITION WITH THE SAFETY PIN INSTALLED.
WARNING : STOP THE OPENING PROCEDURE IF THE RED WARNING LIGHT FLASHES.
_______ RESIDUAL PRESSURE COULD CAUSE THE DOOR TO OPEN WITH A SUDDEN FORCE AND INJURE PERSONS AND/OR DAMAGE THE AIRCRAFT.
1EFF : ALL 1 52-10-00Page 602 1 1 Aug 01/05 1 1 1CES 1
(1)
Put an access platform in position in front of the passenger/crew door 831 or 841.
(2)
Open the passenger/crew door (Ref. TASK 52-10-00-010-001).
(3)
Obey the special precautions before you start work on the door (Ref. TASK 52-10-00-860-001).
Subtask 52-10-00-865-081
B. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------121VU EIS/SLIDES/ARM AND WARN/FLT 15WN P11 121VU EIS/SLIDES/ARM AND WARN/GND 13WN P10 121VU EIS/SDAC1 AND 2/DOOR/DET/PAX 48WV P05
**ON A/C 001-002,
Subtask 52-10-00-010-080
C. Removal of the Components
(1)
Remove the escape slide (Ref. TASK 25-62-44-000-002).
(2)
Remove the door linings:
R (a) For the FWD passenger/crew doors (Ref. TASK 25-23-46-000-001):
-
For the left door: 831AZ, 831BZ, 831CZ, 831DZ, 831EZ, 831FZ and 831GZ.
-
For the right door: 841AZ, 841BZ, 841CZ, 841DZ, 841EZ, 841FZ and 841GZ.
(b) For the AFT passenger/crew doors (Ref. TASK 25-23-46-000-002):
-
For the left door: 832AZ, 832BZ, 832CZ, 832DZ, 832EZ, 832FZ and 832GZ.
-
For the right door: 842AZ, 842BZ, 842CZ, 842DZ, 842EZ, 842FZ and 842GZ.
(3)
Remove the door insulation.
(4)
Install the BALLAST WEIGHT - PASSENGER CREW DOOR (98D52103501000) (Ref. TASK 52-10-00-480-001).
1EFF : ALL 1 52-10-00Page 603 1 1 May 01/05 1 1 1CES 1R **ON A/C 003-049, 051-099, 101-149, 151-199, 201-299, 301-399, 401-499,
Subtask 52-10-00-010-080-A
C. Removal of the Components
(1)
Remove the escape slide/raft (Ref. TASK 25-62-44-000-002).
(2)
Remove the door linings:
(a)
For the FWD passenger/crew doors (Ref. TASK 25-23-46-000-001):
-
For the left door: 831AZ, 831BZ, 831CZ, 831DZ, 831EZ, 831FZ and 831GZ.
-
For the right door: 841AZ, 841BZ, 841CZ, 841DZ, 841EZ, 841FZ and 841GZ.
(b)
For the AFT passenger/crew doors (Ref. TASK 25-23-46-000-002):
-
For the left door: 832AZ, 832BZ, 832CZ, 832DZ, 832EZ, 832FZ and 832GZ.
-
For the right door: 842AZ, 842BZ, 842CZ, 842DZ, 842EZ, 842FZ and 842GZ.
(3)
Remove the door insulation.
(4)
Install the BALLAST WEIGHT - PASSENGER CREW DOOR (98D52103501000) (Ref. TASK 52-10-00-480-001).
**ON A/C ALL
4. Procedure
_________
Subtask 52-10-00-210-077
A. Inspection of the Door Mechanisms
(1) Do a detailed visual inspection of the passenger/crew door for integrity and good adjustment of the door mechanisms. This inspection includes the girt bar.
(a) Do an inspection of the locking mechanism and the release mechanism of the emergency escape slide.
1 Make sure that there are no signs of corrosion, scoring,
_
cracks, marks and damage.
1EFF : ALL 1 52-10-00Page 604 1 1 Aug 01/05 1 1 1CES 1
(b) Do an inspection of the safety devices (cotter pins and lockwire) of the locking mechanism and of the release mechanism of the escape slide.
1 Make sure that the safety devices are correctly installed.
_
Subtask 52-10-00-220-070
B. Check of Door Adjustments
**ON A/C 001-002,
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM DOORS 艙門1(100)
