B. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
24-42-00-861-001 Energize the Ground Service Network from the External Power 25-23-46-000-001 Removal of the Door Linings at the FWD Passenger/Crew Doors
R 25-62-44-000-002 Removal of the Escape-Slide Pack-Assembly 52-00-00-481-001 Installation of the Safety Barriers 52-10-00-010-001 Opening of the Passenger/Crew Door 52-10-00-860-001 Special Precautions before Work on the Passenger/Crew Door 52-11-12-000-003 Removal of the Guide Arms 52-11-11-991-001 Fig. 401 52-11-11-991-003 Fig. 402 52-11-11-991-004 Fig. 403
1EFF : ALL 1 52-11-11Page 401 1 1 Feb 01/04 1 1 1CES 1
3. Job Set-up
__________
Subtask 52-11-11-861-050
R A. Energize the ground service network (Ref. TASK 24-42-00-861-001)
Subtask 52-11-11-010-052
B. Get Access
WARNING : BEFORE YOU START WORK ON THE DOOR, MAKE SURE THAT:
_______
-
THE EMERGENCY CONTROL HANDLE IS IN THE DISARMED POSITION WITH THE SAFETY PIN INSTALLED.
-
THE PERCUSSION LEVER OF THE DOOR-DAMPER AND EMERGENCY-OPERATION CYLINDER IS IN THE DISARMED POSITION WITH THE SAFETY PIN INSTALLED.
WARNING : DO NOT OPEN THE PASSENGER/CREW DOOR IF THE WIND SPEED IS MORE
_______
THAN 65 KNOTS.
WARNING : STOP THE OPENING PROCEDURE IF THE RED WARNING LIGHT FLASHES.
_______ RESIDUAL PRESSURE COULD CAUSE THE DOOR TO OPEN WITH A SUDDEN FORCE AND INJURE PERSONS AND/OR DAMAGE THE AIRCRAFT.
(1)
Put the access platform in position at the applicable FWD passenger crew/door 831 or 841.
(2)
Open the applicable FWD passenger/crew door 831 or 841 (Ref. TASK 52-10-00-010-001).
(3)
Obey the special precautions before you start work on the door (Ref. TASK 52-10-00-860-001)
Subtask 52-11-11-865-050
C. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------121VU EIS/SLIDES/ARM AND WARN/FLT 15WN P11 121VU EIS/SLIDES/ARM AND WARN/GND 13WN P10 121VU EIS/SDAC1 AND 2/DOOR/DET/PAX 48WV P05
1EFF : ALL 1 52-11-11Page 402 1 1 May 01/04 1 1 1CES 1 **ON A/C 001-002,
Subtask 52-11-11-010-050
D. Removal of Component
(1)
Remove the escape slide (Ref. TASK 25-62-44-000-002).
(2)
Remove the door lining panels (Ref. TASK 25-23-46-000-001).
(a)
For the left door: 831FZ, 831CZ, 831DZ, 831AZ, 831BZ, 831EZ, 831GZ
(b)
For the right door: 841FZ, 841CZ, 841DZ, 841AZ, 841BZ, 841EZ, 841GZ
(3) Remove the door insulation blankets. R **ON A/C 003-049, 051-099, 101-149, 151-199, 201-299, 301-399, 401-499,
Subtask 52-11-11-010-050-A
D. Removal of Component
(1)
Remove the escape slide/raft (Ref. TASK 25-62-44-000-002).
(2)
Remove the door lining panels (Ref. TASK 25-62-44-000-002).
(a)
For the left door: 831FZ, 831CZ, 831DZ, 831AZ, 831BZ, 831EZ, 831GZ
(b)
For the right door: 841FZ, 841CZ, 841DZ, 841AZ, 841BZ, 841EZ, 841GZ
(3)
Remove the door insulation blankets.
1EFF : ALL 1 52-11-11Page 403 1 1 Aug 01/05 1 1 1CES 1 1EFF : ALL 1 52-11-11Page 404 1 1 Feb 01/01 1 1 1CES 1
**ON A/C ALL
Subtask 52-11-11-420-052
E. Installation of the Sling (Ref. Fig. 401/TASK 52-11-11-991-001)
(1) Remove the two self-adhesive patches (3) from the hoisting points. Discard the patches.
(2) Remove the two blanking plugs (1) from the door hoisting points
R R (3) Remove the hoist fittings (2) from the SLING - PASSENGER DOOR (98A52108004001).
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM DOORS 艙門1(130)
