(d)
Make sure that the load necessary to open and close the door is less than or equal to 16 daN (35.9694 lbf).
(e)
Adjust the door locking mechanism:
-
For the FWD passenger/crew door (Ref. TASK 52-11-21-820-001).
-
For the AFT passenger/crew door (Ref. TASK 52-13-21-820-001).
(f)
Remove the BALLAST WEIGHT - PASSENGER CREW DOOR (98D52103501000) (Ref. TASK 52-10-00-080-001).
(g)
Install the escape slide/raft (Ref. TASK 25-62-44-400-001).
1EFF : ALL 1 52-10-00Page 514 1 1 Aug 01/05 1 1 1CES 1
Inner Control Handle of the Passenger/Crew Door Figure 502A/TASK 52-10-00-991-011-A
R 1EFF : 003-049, 051-099, 101-149, 151-199, 1 52-10-00Page 515 1201-299, 301-399, 401-499, 1Aug 01/05 1 1 1CES 1 **ON A/C ALL
Subtask 52-10-00-010-056
C. Opening of the Door
(1) Open the passenger/crew door from the inner side.
5. Close-up
________ Subtask 52-10-00-865-055
A. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s): 13WN, 15WN, 48WV.
Subtask 52-10-00-410-057
B. Close Access
(1)
Obey the special precautions after the work on the door (Ref. TASK 52-10-00-860-002).
(2)
Make sure that the work area is clean and clear of tool(s) and other items.
(3)
Close the applicable passenger/crew door 831 (841) or 832 (842) (Ref. TASK 52-10-00-410-001).
(4)
Remove the access platform(s).
1EFF : ALL 1 52-10-00Page 516 1 1 May 01/05R 1 1 1CES 1
INTENTIONALLY BLANK
R 1 1
52-10-00Page 517
1 1 Feb 01/05 1 1 1CES 1
INTENTIONALLY BLANK
R 1 1
52-10-00Page 518
1 1 May 01/04 1 1 1CES 1 TASK 52-10-00-710-001
Operational Test of the Damping Function of the Door-Damper and Emergency-Operation when you Open and Close the Passenger/Crew Door
1.
Reason for the Job
__________________
Refer to the MPD TASK: 521000-10
2.
Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific access platform 3.5 m (11 ft. 6 in.)
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
52-10-00-010-001 Opening of the Passenger/Crew Door 52-10-00-410-001 Closing of the Passenger/Crew Door 52-10-00-860-001 Special Precautions before Work on the Passenger/Crew
Door 52-10-00-860-002 Special Precautions after Work on the Passenger/Crew Door
3. Job Set-up
__________ Subtask 52-10-00-010-057
A. Get Access WARNING : DO NOT OPEN THE PASSENGER/CREW DOOR IF THE WIND SPEED IS MORE
_______
THAN 65 KNOTS.
WARNING : BEFORE YOU START WORK ON THE DOOR, MAKE SURE THAT:
_______
-
THE EMERGENCY CONTROL HANDLE IS IN THE DISARMED POSITION WITH THE SAFETY PIN INSTALLED.
-
THE PERCUSSION LEVER OF THE DOOR-DAMPER AND EMERGENCY-OPERATION CYLINDER IS IN THE DISARMED POSITION WITH THE SAFETY PIN INSTALLED.
1EFF : ALL 1 52-10-00Page 519 1 1 May 01/98R 1 1 1CES 1
WARNING : STOP THE OPENING PROCEDURE IF THE RED WARNING LIGHT FLASHES.
_______ RESIDUAL PRESSURE COULD CAUSE THE DOOR TO OPEN WITH A SUDDEN FORCE AND INJURE PERSONS AND/OR DAMAGE THE AIRCRAFT.
(1)
Put the access platform in position in front of the passenger/crew door 831 or 832 or 841 or 842.
(2)
Open the applicable passenger/crew door 831, 841 or 832, 842 (Ref. TASK 52-10-00-010-001).
(3)
Obey the special precautions before you start work on the door (Ref. TASK 52-10-00-860-001).
4. Procedure
_________
Subtask 52-10-00-710-051
A. Operational Test of the Damper and Emergency-Operation Cylinder for Correct Operation.
(1) Check the correct operation as follows:
(a) At the end of the door opening, damping is correct when there is no hard impact of the buffer on the aircraft structure. The operator must feel the door damping and the correct engagement of the door locking hook (door in the open position).
NOTE : After the extension and before the retraction of the
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM DOORS 艙門1(91)
