B. Consumable Materials
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
Material No. 19-010 USA AMS 5687
LOCKWIRE STAINLESS STEEL ANNEALED 0.8MM DIA
(Ref. 20-31-00)
1EFF : ALL 1 52-10-00Page 420 1 1 May 01/04 1 1 1CES 1 C. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
25-23-46-000-002 Removal of the Door Linings at the AFT Passenger/Crew Doors
25-23-46-400-001 25-23-46-400-002 25-62-44-400-001 52-10-00-010-001 52-10-00-410-001 52-10-00-860-001 Installation of the Door Linings at the FWD Passenger/Crew DoorsInstallation of the Door Linings at the AFT Passenger/Crew DoorsInstallation of the Escape-Slide Pack-AssemblyOpening of the Passenger/Crew DoorClosing of the Passenger/Crew DoorSpecial Precautions before Work on the Passenger/Crew Door
52-10-00-860-002 Special Precautions after Work on the Passenger/Crew Door
52-11-00-820-002 52-13-00-820-002 Load Adjustment of the Control Handle of the FWD Passenger/Crew DoorLoad Adjustment of the Control Handle of the AFT Passenger/Crew Door without the Emergency Escape Slide
**ON A/C 001-002,
52-10-00-991-040 Fig. 402
R **ON A/C 003-049, 051-099, 101-149, 151-199, 201-299, 301-399, 401-499, 52-10-00-991-040-A Fig. 402A
1EFF : ALL 1 52-10-00Page 421 1 1 Aug 01/05 1 1 1CES 1
**ON A/C ALL
3. Job Set-up
__________
Subtask 52-10-00-010-087
A. Get Access
R (1) Put the access platform in position in the zone 831 (841) or 832 R (842).
(2)
Open the door 831, 841 or 832, 842 (Ref. TASK 52-10-00-010-001).
(3)
Obey the special precautions before you start work on the door (Ref. TASK 52-10-00-860-001).
Subtask 52-10-00-865-077
B. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------
PANEL DESIGNATION IDENT. LOCATION
-------------------------------------------------------------------------------
121VU EIS/SLIDES/ARM AND WARN/FLT 15WN P11 121VU EIS/SLIDES/ARM AND WARN/GND 13WN P10 121VU EIS/SDAC1 AND 2/DOOR/DET/PAX 48WV P05
4. Procedure
_________
**ON A/C 001-002,
Subtask 52-10-00-820-053
A. Load Ajustment of the Inner Control Handle
(Ref. Fig. 402/TASK 52-10-00-991-040)
(1)
Remove the lockwire from the screw (2).
(2)
Adjust the load (less than or equal to 16 daN (35.9694 lbf)) on the inner control handle. To do this tighten the screw (2) by 9 turns to apply a load on the torsion bar (1).
(3)
Do a check of the load adjustment of the inner control handle.
-
For the FWD passenger/crew door (Ref. TASK 52-11-00-820-002).
-
For the Aft passenger/crew door (Ref. TASK 52-13-00-820-002).
1EFF : ALL 1 52-10-00Page 422 1 1 May 01/04 1 1 1CES 1
(4) Safety the screw (2) with MISCELLANEOUS (Material No. 19-010) R **ON A/C 003-049, 051-099, 101-149, 151-199, 201-299, 301-399, 401-499,
Subtask 52-10-00-820-053-A
A. Load Ajustment of the Inner Control Handle
(Ref. Fig. 402A/TASK 52-10-00-991-040-A)
(1)
Remove the lockwire from the screw (2).
(2)
Adjust the load (less than or equal to 16 daN (35.9694 lbf)) on the inner control handle. To do this tighten the screw (2) by 20 turns to apply a load on the torsion bar (1).
(3)
Do a check of the load adjustment of the inner control handle.
-
For the FWD passenger/crew door (Ref. TASK 52-11-00-820-002).
-
For the Aft passenger/crew door (Ref. TASK 52-13-00-820-002).
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM DOORS 艙門1(86)
