曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

R  number of holes to give access to the inside of the spar box. An 
R  intermediate spar is riveted between rib 1 and rib 2. Each spar has a 
R  transverse-load fitting at its lower end. 
R  (5) The spar box has eleven ribs. Except for rib 1 and rib 2, they are at 
R  right angles to the rear spar. The center spar divides rib 1 into 
R  two. All ribs are riveted to the side shells, webs and through angles 
R  to the spars. Hi-Lok fasteners are used to attach them. 
R  (6) Two hoisting points are installed on each side of the spar box. Each 
R  hoisting point has a threaded sleeve which is bonded into the side 
R  shell. There is a plastic plug in each hoisting point, that must be 
R  removed before the hoist fitting is installed. When the hoisting 
R  points are not in use they are covered with self adhesive disks. 
R  (7) Each side shell has four levelling points.

 

 Vertical Stabilizer Spar Box
 Figure 001
 1EFF :  ALL  1  55-31-00 Page 2 
1  1  Feb 01/98
 1  1
 1CES  1

 

 SPAR BOX - VERTICAL STABILIZER - REMOVAL/INSTALLATION
_____________________________________________________
 TASK 55-31-11-000-001
 Removal of the Vertical Stabilizer
 WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU_______ START A TASK ON OR NEAR: - THE FLIGHT CONTROLS - THE FLIGHT CONTROL SURFACES - THE LANDING GEAR AND THE RELATED DOORS - COMPONENTS THAT MOVE.
 WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROL SURFACES ARE_______ CLEAR BEFORE YOU PRESSURIZE/DEPRESSURIZE A HYDRAULIC SYSTEM.
 CAUTION : DO NOT CAUSE DAMAGE TO THE SURFACES. THE COMPONENTS ARE MADE OF_______ CARBONFIBER REINFORCED PLASTIC.
 1. Reason for the Job__________________
 Self Explanatory
 2. Job Set-up Information______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------
REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
RRR R R  No specific No specific No specific No specific No specific No specific No specific No specific No specific SL90-314-5625 SL90-322-5625 98D27207516000 98D27207549000 98D55307503001  blanking plugscircuit breaker(s) safety clip(s) supportwarning noticeadjustable access platform 6 m (19 ft. 8 in.)crane 800 kg (1763.6976 lb) 1 CAP - BLANKING 1 CONTAINER 3 L(3/4 USGAL) 1 SCALE 1000 KG (2200 LB)1 TOOL - EXTRACTION, TAB WASHERS STA-LOK NSA54541 WRENCHES - NOTCHED, TIGHTENING OF NUTS NSA54541 RIGGING PIN SET1 PIN - RIGGING1 CENTERING BOLTS - VERT. STABILIZER

 

 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
98D55307518000 1 SLING - R/I VERTICAL STABILIZER AND RUDDER R 98D55308369000 1 EXTRACTOR - BOLTS, VERTICAL STABILIZER
 B. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
29-00-00-864-001 Put the Related Hydraulic System in the Depressurized
 Configuration before Maintenance Action 29-00-00-910-002 Safety Procedures of the Hydraulic System 51-78-00-615-002 Aircraft Cleaning after a Hydraulic Fluid Leakage 53-45-11-000-001 Removal of the Dorsal Fin 321AL 53-55-11-000-001 Removal of the Fairings 323AL/323AR 53-55-12-000-001 Removal of the Rudder Fairings 325AL and 325AR 55-33-13-010-002 Opening/Removal of the Trailing Edge Access-Panels
 325EL, 325ER, 325DL, 325DR, 325CL, 325CR, 325BL and
 325BR
 55-43-19-000-001 Removal of the Rudder Fillet Fairing
 55-31-11-991-005 Fig. 401
 55-31-11-991-001 Fig. 402
 55-31-11-991-002 Fig. 403
 55-31-11-991-003 Fig. 404
 55-31-11-991-006 Fig. 405

 3. Job Set-up
__________
 Subtask 55-31-11-864-050
 A. Hydraulic Safety Procedure
 WARNING : OBEY THE HYDRAULIC SAFETY PROCEDURES.
_______
 (1)
 Depressurize the Green, Yellow and Blue hydraulic systems (Ref. TASK 29-00-00-864-001).

 (2)
 Depressurize the Green, Yellow and Blue hydraulic reservoir.

 (3)
 Obey the hydraulic safety procedure (Ref. TASK 29-00-00-910-002).

 

 Subtask 55-31-11-865-050

 B. Open, safety and tag this(these) circuit breaker(s):
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM STABILIZERS 安定面(73)