(2)
Make sure that the ground safety locks are on the landing gear (Ref. TASK 32-00-00-481-001).
(3)
On the panel 400VU:
-make sure that the landing-gear control-lever 6GA is in the DOWN position
-put a warning notice in position to tell persons not to operate the landing gear.
(4)
On the panel 110VU, make sure that the GRAVITY GEAR EXTN handle is folded into the center console.
(5)
Install a wedge on each side of the GRAVITY GEAR EXTN handle to lock the handle in position.
1EFF : ALL 1 32-33-00Page 603 1 1 Aug 01/05 1 1 1CES 1
Cockpit and Cabin Floor Panels Figure 601/TASK 32-33-00-991-019
1EFF : 1 1R 1CES ALL 1 11 1 32-33-00 Page 604 Nov 01/02
Forward Cargo-Compartment Access Panels
Figure 602/TASK 32-33-00-991-020
R 1EFF : 001-049, 051-099, 101-149, 201-299, 1 32-33-00Page 605 1301-399, 1May 01/05 1 1 1CES 1
Forward Cargo-Compartment Access Panels Figure 602A/TASK 32-33-00-991-020-A
R 1EFF : 151-199, 401-499, 1 32-33-00Page 606 1 1 Aug 01/05 1 1 1CES 1
R Cabin Floor Panels Figure 603/TASK 32-33-00-991-021
1EFF : 1 1 1CES ALL 1 111 32-33-00 Page 607 Nov 01/04
**ON A/C 001-049, 051-099, 101-149, 201-299, 301-399,
Subtask 32-33-00-010-050
B. Get Access
(1)
Open the NLG doors (Ref. TASK 32-22-00-010-001).
(2)
Make sure that a SAFETY PIN - NLG DOOR is installed in each NLG door.
(3)
Open the MLG doors 734, 744 (Ref. TASK 32-12-00-010-001).
(4)
Make sure that the GROUND LOCK SLEEVE is on the applicable MLG door actuator.
(5)
Open the lateral avionics-compartment door 822.
(6)
Open the forward cargo-compartment door 825 (Ref. TASK 52-30-00-860-001).
(7)
Remove the forward cargo-compartment ceiling panels 131AC, 131BC, 131CC.
(8)
Remove the cockpit floor panels 211FF, 211JF (Ref. TASK 53-12-11-000-001).
(9)
Remove the applicable passenger seats to get access to the floor panels 241LF, 242LF (Ref. TASK 25-21-41-000-001).
(10) Remove the passenger-compartment floor panels 241LF and 242LF (Ref. TASK 53-32-12-000-002).
R **ON A/C 151-199, 401-499,
Subtask 32-33-00-010-050-A
B. Get Access
(1)
Open the NLG doors (Ref. TASK 32-22-00-010-001).
(2)
Make sure that a SAFETY PIN - NLG DOOR is installed in each NLG door.
(3)
Open the MLG doors 734, 744 (Ref. TASK 32-12-00-010-001).
1EFF : ALL 1 32-33-00Page 608 1 1 Aug 01/05 1 1 1CES 1
(4)
Make sure that the GROUND LOCK SLEEVE is on the applicable MLG door actuator.
(5)
Open the lateral avionics-compartment door 822.
(6)
Open the forward cargo-compartment door 825 (Ref. TASK 52-30-00-860-001).
(7)
Remove the forward cargo-compartment ceiling panels 131MC, 131NC.
(8)
Remove the cockpit floor panels 211FF, 211JF (Ref. TASK 53-12-11-000-001).
R (9) Remove the applicable passenger seats to get access to the floor R panels 241LF, 242LF (Ref. TASK 25-21-41-000-001).
(10) Remove the passenger-compartment floor panels 241LF and 242LF (Ref. TASK 53-32-12-000-002).
**ON A/C ALL
Subtask 32-33-00-480-051
C. Installation of the Rigging Pins R (Ref. Fig. 604/TASK 32-33-00-991-003)
(1)
Put in the RIGGING PIN (98A27801001000) at position Pin 1.
(2)
Put in the RIGGING PIN (98A27003001000) at position Pin 2.
(3)
Put the RIGGING PIN (98DNSA20208060) at positions Pin 3 and Pin 4.
(4)
Put in the PIN, RIGGING - RUDDER CONTROL (98A27901002000) at position Pin 5.
(5)
Make sure that the pins lock the related pulley, cable quadrant or lever.
4. Procedure
_________
CAUTION : MAKE SURE THAT THE FREE-FALL EXTENSION CABLES ARE ADJUSTED
_______ CORRECTLY. INCORRECT ADJUSTMENT OF THE CABLES CAN CAUSE THE FREE-FALL EXTENSION SYSTEM TO BE UNSERVICEABLE.
1EFF : ALL 1 32-33-00Page 609 1 1 Aug 01/04 1 1 1CES 1
Free-Fall Cable System Details Figure 604/TASK 32-33-00-991-003- 12 (SHEET 1)
1EFF : 1 1R 1CES ALL 1 11 1 32-33-00 Page 610 Nov 01/02
Free-Fall Cable System Details Figure 604/TASK 32-33-00-991-003- 22 (SHEET 2)
1EFF : 1 1R 1CES ALL 1 11 1 32-33-00 Page 611 Nov 01/02
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM LANDING GEAR 起落架5(125)
