C. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
30-42-00-710-001 Operational Test of the Windshield Anti-Icing and
Defogging 56-10-00-110-002 Cleaning of the L/R Fixed Windows 56-11-12-991-053 Fig. 404 56-11-12-991-054 Fig. 405 56-11-12-991-055 Fig. 406 56-11-12-991-056 Fig. 407 56-11-12-991-057 Fig. 408
3. Job Set-up
__________
Subtask 56-11-12-869-053
A. Aircraft Maintenance Configuration
(1) Make sure that the access platform is in position at zone 210.
Subtask 56-11-12-865-057
B. Make sure that this(these) circuit breaker(s) is(are) open, safetied and tagged
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
121VU COM NAV/RADAR/1 5SQ1 K13
FOR 7DG1 122VU ANTI ICE/WINDOWS/L 4DG1 X14 122VU ANTI ICE/WHC/1 5DG1 X13 123VU ANTI ICE/L/WHSLD 1DG1 AF10
FOR 7DG2 122VU ANTI ICE/WINDOWS/R 4DG2 W14 122VU ANTI ICE/WHC/2 5DG2 W13 123VU ANTI ICE/R/WHSLD 1DG2 AF03
Subtask 56-11-12-914-060
C. Preparation For the Installation
(1) Clean the housing of the window with CLEANING AGENTS (Material No. 11-002) and a MISCELLANEOUS (Material No. 19-003).
R 1EFF : 001-049, 101-149, 151-199, 201-299, 1 56-11-12Page 421 1301-399, 401-499, 1Aug 01/05 1 1 1CES 1
4. Procedure
_________
Subtask 56-11-12-420-062
A. Installation of the Fixed Window Panel (Ref. Fig. 404/TASK 56-11-12-991-053, 405/TASK 56-11-12-991-054)
WARNING : BE CAREFUL DURING THE REMOVAL/INSTALLATION OF THE WINDOW TO
_______ PREVENT INJURY TO PERSONS AND/OR DAMAGE. MAKE SURE THAT: -THERE ARE SUFFICIENT PERSONS FOR THE TASK. -YOU DO NOT CAUSE DAMAGE TO THE SEAL OR THE GLASS PLIES. THE WINDOW IS HEAVY.
(1)
Put the fixed window panel (13) in position in its housing.
(2)
Apply SPECIAL MATERIALS (Material No. 05-002) in the housings of the heads of the screws (12).
(3)
Install the screws (12).
(4)
Remove the blanking caps from the electrical connectors.
(5)
Connect the sensor (11) to the receptacle (14).
R **ON A/C 001-049, 101-108, 151-199, 201-299, 301-399,
Subtask 56-11-12-820-054
B. Adjustment of the Fixed Window (Ref. Fig. 406/TASK 56-11-12-991-055, 407/TASK 56-11-12-991-056, 408/TASK 56-11-12-991-057)
(1)
For the acrylic fixed window (LUCAS supplier, P/N NH...) put the fixed window panel in position to get:
-
the clearance J1 of 1.2 +0.8 -0.8 mm (0.0472 +0.0314 -0.0314 in.)
-
the clearance J2 of 0.7 mm (0.0275 in.) minimum.
(2)
For the glass fixed window (PPG supplier, P/N NP...) put the fixed window panel in position to get:
-the clearance J1 of 1.2 +0.8 -0.8 mm (0.0472 +0.0314 -0.0314 in.)
(3)
For the glass fixed window (SPS supplier, P/N SPSA... put the fixed window panel in position to get:
-the clearance J1 of 1.2 +0.8 -0.8 mm (0.0472 +0.0314 -0.0314 in.)
R 1EFF : 001-049, 101-149, 151-199, 201-299, 1 56-11-12Page 422 1301-399, 401-499, 1Aug 01/05 1 1 1CES 1
Acrylic Fixed Windows (LUCAS/ACT Supplier) - Clearances
Figure 406/TASK 56-11-12-991-055
R 1EFF : 001-049, 101-149, 151-199, 201-299, 1 56-11-12Page 423 1301-399, 401-499, 1Aug 01/05 1 1 1CES 1
Glass Fixed Windows (PPG Supplier) - Clearances
Figure 407/TASK 56-11-12-991-056
R 1EFF : 001-049, 101-149, 151-199, 201-299, 1 56-11-12Page 424 1301-399, 401-499, 1Aug 01/05 1 1 1CES 1
Glass Fixed Windows (SPS Supplier) - Clearances
Figure 408/TASK 56-11-12-991-057
R 1EFF : 001-049, 101-149, 151-199, 201-299, 1 56-11-12Page 425 1301-399, 401-499, 1Aug 01/05 1 1 1CES 1
R **ON A/C 109-149, 401-499,
R Subtask 56-11-12-820-054-A
R R B. Adjustment of the Fixed Window (Ref. Fig. 406/TASK 56-11-12-991-055, 407/TASK 56-11-12-991-056, 408/TASK 56-11-12-991-057)
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM WINDOWS 風擋 窗戶(39)
