R 1EFF : 051-099, 1 56-12-11Page 461 1 1 May 01/05 1 1 1CES 1

R C. Referenced Information

R -------------------------------------------------------------------------------R REFERENCE DESIGNATION R -------------------------------------------------------------------------------
R 33-12-12-000-002 R 33-12-18-000-001 R 52-10-00-010-001 R 56-12-11-010-001 R 56-12-11-991-030 R 56-12-11-991-029
R 3. Job Set-up
__________
R Subtask 56-12-11-941-062
R A. Get Access Removal of the Map Table Lights (41LE, 42LE) Removal of the Map Table Light Rheostats (39LE, 40LE) Opening of the Passenger/Crew Door Opening of the Cockpit Sliding Windows Fig. 414 Fig. 415
R (1) Put the access platform in position at the zone 210 in front of the R sliding window.
R Subtask 56-12-11-865-057
R B. Open, safety and tag this(these) circuit breaker(s):
R -------------------------------------------------------------------------------R PANEL DESIGNATION IDENT. LOCATION R -------------------------------------------------------------------------------R 121VU COM NAV/RADAR/2 5SQ2 K14 R 121VU COM NAV/RADAR/1 5SQ1 K13 R FOR 8DG1 R 122VU ANTI ICE/WINDOWS/L 4DG1 X14 R 122VU ANTI ICE/WHC/1 5DG1 X13 R 123VU ANTI ICE/L/WHSLD 1DG1 AF10 R FOR 8DG2 R 122VU ANTI ICE/WINDOWS/R 4DG2 W14 R 122VU ANTI ICE/WHC/2 5DG2 W13 R 123VU ANTI ICE/R/WHSLD 1DG2 AF03
R 1EFF : 051-099, 1 56-12-11Page 462 1 1 May 01/05 1 1 1CES 1

R Subtask 56-12-11-010-059

R  C. Get Access 
R  (1) Put an access platform in position at the FWD passenger/crew door 
R  831. 
R  (2) Open the FWD passenger/crew door (Ref. TASK 52-10-00-010-001). 
R  Subtask 56-12-11-020-060 
R  D. Removal of Component 
R  (1) Remove the map table light (Ref. TASK 33-12-12-000-002). 
R  FOR 8DG1 
R  41LE 
R  FOR 8DG2 
R  42LE 
R  (2) Remove the map table light rheostats (Ref. TASK 33-12-18-000-001). 
R  FOR 8DG1 
R  39LE 
R  FOR 8DG2 
R  40LE 
R  Subtask 56-12-11-020-061 
R  E. Removal of the Sliding Window Lining 
R  (Ref. Fig. 414/TASK 56-12-11-991-030) 
R  (1) Open the sliding window (Ref. TASK 56-12-11-010-001). 
R  (2) Remove the screw (5) and remove the pencil holder assembly (7). 
R  (3) Remove the screw (21) and the washer (20). 
R  (4) Remove the screw (19) and the washer (18). 
R  (5) Remove the handle (6). 
R  (6) Remove the screw (9) and the washer (8). 
R  (7) Remove the screw (15) and the washer (14). 
R  (8) Close the sliding window. 

R 1EFF : 051-099, 1 56-12-11Page 463 1 1 May 01/05 1 1 1CES 1

R  Sliding Window lining 
R  Figure 414/TASK 56-12-11-991-030 
R 1EFF :  051-099,  1  56-12-11 Page 464 
1  1  May 01/05
 1  1
 1CES  1

R  (9) Remove the blanking plug (4), remove the screw (3) and the washer 
R  (2). 
R  (10) Remove the screws (11). 
R  (11) Remove the screws (12). 
R  (12) Lift the plate (17) and remove the sliding window lining (16). 
R  (13) Disconnect the electrical connector (10) from the receptacle. 
R  (14) Put blanking caps on the disconnected electrical connectors. 
R  4. Procedure_________ 
R  Subtask 56-12-11-020-062 
R  A. Removal of the Sliding Window Panel 
R  (Ref. Fig. 415/TASK 56-12-11-991-029) 
R  CAUTION : BE CAREFUL DURING THE REMOVAL/INSTALLATION OF EACH SLIDING_______ 
R  WINDOW PANEL TO PREVENT INJURY TO PERSONS AND /OR DAMAGE. 
R  MAKE SURE THAT THERE ARE SUFFICIENT PERSONS DURING THE 
R  OPERATION. EACH WINDOW PANEL WEIGHS APPROXIMATELY 20Kg 
R  (44.11b). 
R  (1) Loosen the screws (32). Loosen the screw located behind the axis of 
R  the control handle with the WRENCH, REMOVAL - SLIDING WINDOW 
R  (98D56103002001). 
R  (2) Use 2 suction cups to hold and move the sliding window panel (30). 
R  (3) Hold the window panel (30) in position and remove the screws (32), 
R  the washers (33). 
R  (4) Move the frame of the sliding window to the open position (the 
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM WINDOWS 風擋 窗戶(63)