曝光臺 注意防騙 網(wǎng)曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

R  (i) TORQUE the nuts (41), (44), (47) and (50) to between 0.6 and 0.7 
R  m.daN (53.09 and 61.94 lbf.in). 
R  (j) Safety the nuts (41), (44), (47) and (50) with the lockwashers 
R  (52), (53), (54) and (55). 
R  (k) Install the circlips (42), (45), (46) and (51). 
R  **ON A/C 051-099, 
R  Subtask 56-12-11-220-060 
R  D. Adjustment of the Handle 
R  (1) Check of the load necessary to operate the handle 
R  NOTE : The load on the handle is directly related to the out-of-flush____ 
R  adjustment of the window. 
R  (a) Operate the sliding window. Measure the load on the handle 
R  perpendicularly with a dynamometer. 
R  (b) The load permitted on the handle is 20 +2 -3 daN (44.9617 +4.4961 
R  -6.7442 lbf) . If the load is not in the tolerance, adjust the 
R  sliding window again. 
R  NOTE : We recommend that you adjust the window to get a load on____ 
R  the handle near the maximum limit.

 

R Subtask 56-12-11-210-061

R  E. Sealing Check 
R  (1) Close the sliding window 
R  (2) Apply water to the periphery of the sliding window from the outside 
R  of the aircraft 
R  (3) Wait ten minutes and make sure that there is no water leakage at 
R  level of the window frame. 
R  (4) If water goes into the cockpit, make sure that the adjustments are 
R  correct and that the seal is in the correct condition. 
R  (5) Dry if necessary. 
R  5. Close-up________ 
R  Subtask 56-12-11-420-060 
R  A. Installation of the Sliding Window Lining 
R  (Ref. Fig. 414/TASK 56-12-11-991-030) 
R  (1) Lift the plate (17) and put the sliding window lining (16) in 
R  position. 
R  (2) Put the plate (17) in position, install the screws (12) and tighten 
R  them. 
R  (3) Install the screws (11) and tighten them. 
R  (4) Install the washer (2) and the screw (3). 
R  (5) Tighten the screw (3). 
R  (6) Install the blanking plug (4). 
R  (7) Open the sliding window. 
R  (8) Install the guide (13) on the sliding window lining (16) with the 
R  washer (14) and the screw (15). 
R  (9) Tighten the screw (15). 
R  (10) Install the washer (8) and the screw (9).

 1EFF : 051-099, 1 56-12-11Page 479 1 1 May 01/05 1 1 1CES 1 1EFF : 051-099, 1 56-12-11Page 480 1 1 May 01/05 1 1 1CES 1

R  (11) Tighten the screw (9). 
R  (12) Put the handle (6) in position. 
R  (13) Install the washer (20) and the screw (21). 
R  NOTE : Do not tighten the screw (21) fully.____ 
R  (14) Install the washer (18) and the screw (19). 
R  (15) Tighten the screw (19) and (21). 
R  (16) Put the pencil holder assembly (7) in position. 
R  (17) Install the screw (5) and tighten it. 
R  (18) Connect the electrical connector (10). 
R  (19) Close the sliding window (Ref. TASK 56-12-11-410-001). 
R  Subtask 56-12-11-420-061 
R  B. Installation of Component 
R  (1) Install the map table light (Ref. TASK 33-12-12-400-002). 
R  FOR 8DG1 
R  41LE 
R  FOR 8DG2 
R  42LE 
R  (2) Install the map table light rheostats (Ref. TASK 33-12-18-400-001). 
R  FOR 8DG1 
R  39LE 
R  FOR 8DG2 
R  40LE 
R  Subtask 56-12-11-865-061 
R  C. Remove the safety clip(s) and the tag(s) and close this(these) circuit 
R  breaker(s): 
R  1DG1, 4DG1, 5DG1, 1DG2, 4DG2, 5DG2, 5SQ1, 5SQ2. 
R  (1) Remove the safety clip(s) and the tag(s) and close this(these) 
R  circuit breaker(s):

 

R Subtask 56-12-11-710-051

R  D. Test 
R  (1) Do the operational test of the anti-icing and defogging of the 
R  sliding windows (Ref. TASK 30-42-00-710-001). 
R  Subtask 56-12-11-110-060 
R  E. Cleaning of the Sliding Window 
R  (1) Clean the sliding window (Ref. TASK 56-10-00-110-003). 
R  Subtask 56-12-11-942-057 
R  F. Close Access 
R  (1) Close the FWD passenger/crew door (Ref. TASK 52-10-00-410-001). 
　
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護(hù)手冊 AMM WINDOWS 風(fēng)擋 窗戶(67)