曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 3. Job Set-up
__________
 Subtask 56-12-11-941-066
 A. Get Access
 (1) Put the access platform in position at the zone 210 in front of the sliding window.
 Subtask 56-12-11-865-062
 B. Open, safety and tag this(these) circuit breaker(s):
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
121VU COM NAV/RADAR/1 5SQ1 K13
 FOR 8DG1 122VU ANTI ICE/WINDOWS/L 4DG1 X14 122VU ANTI ICE/WHC/1 5DG1 X13 123VU ANTI ICE/L/WHSLD 1DG1 AF10
 FOR 8DG2 122VU ANTI ICE/WINDOWS/R 4DG2 W14 122VU ANTI ICE/WHC/2 5DG2 W13 123VU ANTI ICE/R/WHSLD 1DG2 AF03
R 1EFF : 001-049, 101-149, 151-199, 201-299, 1 56-12-11Page 432 1301-399, 401-499, 1Aug 01/05 1 1 1CES 1

 Subtask 56-12-11-020-066

 C. Removal of Component
 (1)
 Remove the map table light installed on the sliding window lining (Ref. TASK 33-12-12-000-002). FOR 8DG1 41LE FOR 8DG2 42LE

 (2)
 Remove the map table light rheostats installed on the sliding window lining (Ref. TASK 33-12-18-000-001). FOR 8DG1 39LE FOR 8DG2 40LE

 4. Procedure
_________ Subtask 56-12-11-020-067
 A. Removal of the Lining Panels
 (Ref. Fig. 407/TASK 56-12-11-991-065, 408/TASK 56-12-11-991-066)

 (1)
 Removal of the lining panel (48) 211GW (212GW)

 (a)
 Remove the screws (41) and the washers (40).

 (b)
 Loosen the fasteners (42).

 (c)
 Disengage the lining panel (48) 211GW (212GW).

 (d)
 Remove the screw (45), the washer (44) and disengage the electrical cable (46).

 (e)
 Remove the lining panel (48) 211GW (212GW).

 

 (2)
 Removal of the lining panel (29) 211KC (212KC)

 (a)
 Remove the lining panels (29) 211BC (212BC) and 211FC (212FC).

 (b)
 Loosen the fastener (1).

 (c)
 Remove the screws (24) and the washers (25) from the brackets (26).

 

R 1EFF : 001-049, 101-149, 151-199, 201-299, 1 56-12-11Page 433 1301-399, 401-499, 1Aug 01/05 1 1 1CES 1

 Sliding Windows - Lining Panels
 Figure 407/TASK 56-12-11-991-065

R 1EFF : 001-049, 101-149, 151-199, 201-299, 1 56-12-11Page 434 1301-399, 401-499, 1Aug 01/05 1 1 1CES 1

 Sliding Windows - Lining Panels
 Figure 408/TASK 56-12-11-991-066

R 1EFF : 001-049, 101-149, 151-199, 201-299, 1 56-12-11Page 435 1301-399, 401-499, 1Aug 01/05 1 1 1CES 1

 (d)
 Loosen the clamp (28) and disconnect the duct (27).

 (e)
 Remove the lining panel (29) 211KC (212KC).

 (3) Removal of the sliding window lining (16)
 (a)
 Open the sliding window 8DG1 (8DG2) (Ref. TASK 56-12-11-010-001).

 (b)
 Remove the screw (5) and remove the pencil holder assembly (7).

 (c)
 Remove the screw (21) and the washer (20).

 (d)
 Remove the screw (19) and the washer (18).

 (e)
 Remove the handle (6).

 (f)
 Remove the screw (9) and the washer (8).

 (g)
 Remove the screw (15) and the washer (14).

 (h)
 Close the sliding window.

 (i)
 Remove the blanking plug (4), remove the screw (3) and the washer (2).

 (j)
 Remove the screws (11).

 (k)
 Remove the screws (12).

 (l)
 Lift the plate (17) and remove the sliding window lining (16).

 (m)
 Disconnect the electrical connector (9) from the receptacle.

 (n) Put blanking caps on the disconnected electrical connectors. Subtask 56-12-11-020-068
 B. Removal of the Aft Upper Rail
 (Ref. Fig. 409/TASK 56-12-11-991-067)

 (1)
 Remove the bolts (54),(55) and the nuts (57).

 (2)
 Remove the aft upper rail (56) from its support.

R 1EFF : 001-049, 101-149, 151-199, 201-299, 1 56-12-11Page 436 1301-399, 401-499, 1Aug 01/05 1 1 1CES 1

 Sliding Windows - Removal/Installation
 Figure 409/TASK 56-12-11-991-067

R 1EFF : 001-049, 101-149, 151-199, 201-299, 1 56-12-11Page 437 1301-399, 401-499, 1Aug 01/05 1 1 1CES 1

 Subtask 56-12-11-020-070

 C. Removal of the Sliding Window
 CAUTION : BE CAREFUL WHEN YOU REMOVE THE SLIDING WINDOW.THE HANDLE IS
_______ SPRING -LOADED AND WILL MOVE SUDDENLY WHEN YOU REMOVE THE WINDOW FROM THE TRACK. IF YOU ARE NOT CAREFUL THE HANDLE CAN HIT YOU.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM WINDOWS 風擋 窗戶(56)