C. Expendable Parts
-------------------------------------------------------------------------------
FIG.ITEM |DESIGNATION |IPC-CSN
-------------------------------------------------------------------------------
6 cotter pin 57-55-11 03J-140 6 cotter pin 57-55-11 03U-140 6 cotter pin 57-55-11 03V-140
D. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
20-28-00-912-004 Electrical Bonding of Components With Conductive Bolts and Screws and Bonding Straps in the Fuselage and in the Wings (this does not include the tanks)-
27-50-00-866-009 Retraction of the Flaps on the Ground 27-54-00-710-001 Operational Test of the Flap System 57-55-11-400-001 Installation of the Flap Track Fairings Nos. 2, 3 and
4
R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,
57-55-11-991-007 Fig. 406
**ON A/C 301-399,
57-55-11-991-007-A Fig. 406A **ON A/C ALL
3. Job Set-up
__________
Subtask 57-55-11-941-062
A. Safety Precautions
(1) Make sure that the warning notices are in position in the cockpit to tell persons not to operate the slats or flaps.
(2) Make sure that the safety barriers are in position.
Subtask 57-55-11-860-064
B. Aircraft Maintenance Configuration
(1)
Make sure that the flaps are fully retracted (Ref. TASK 27-50-00-866-009).
(2)
Make sure that the TOOL-ZERO LOCKING, FLAP SLAT CTL LEVER is installed on the flap/slat control lever.
(3)
Make sure that the access platform is in position below the applicable flap track 2, zone 531 (631).
Subtask 57-55-11-865-070
C. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU FLIGHT CONTROLS/FLP/CTL AND MONG/SYS1 6CV B07 121VU FLIGHT CONTROLS/FLP/CTL AND/MONG/SYS2 8CV Q21
4. Procedure
_________ R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,
(Ref. Fig. 406/TASK 57-55-11-991-007) **ON A/C 301-399,
(Ref. Fig. 406A/TASK 57-55-11-991-007-A)
R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,
Subtask 57-55-11-410-056
A. Preparation for Lifting
WARNING : USE SOLVENTS/CLEANING AGENTS, SEALANTS AND OTHER SPECIAL
_______ MATERIALS ONLY WITH A GOOD SUPPLY OF AIR. OBEY THE MANUFACTURERS INSTRUCTIONS. PUT ON PROTECTIVE CLOTHING. DO NOT GET THEM IN YOUR MOUTH. DO NOT SMOKE. DO NOT BREATHE THE GAS. THESE MATERIALS ARE POISONOUS, FLAMMABLE AND SKIN IRRITANT. GET MEDICAL HELP IF YOUR SKIN OR EYES BECOME IRRITATED.
(1)
Move the movable fairing, to align the control rod (7) with the flap drive lever.
(2)
Temporarily install the control rod (7) with the bolt (11), the sliding bush (5), the washer (4) and the nut (3).
(3)
Temporarily install the top cover (1) with some of the screws (2).
(4)
Make sure that the movable fairing is correctly adjusted (Ref. TASK 57-55-11-400-001).
(5)
Hold the movable fairing and remove the nut (3), the washer (4) the sliding bush (5) and the bolt (11).
(6)
Use a MISCELLANEOUS (Material No. 19-003), made moist with CLEANING AGENTS (Material No. 11-004) to clean the interfaces of these items:
-
the bolt (11) and the sliding bush (5)
-
the flap drive control lever
-
the control rod (7)
-
the washer (4) and the nut (3)
R **ON A/C 301-399,
R Subtask 57-55-11-410-056-A
R A. Preparation for Lifting
R WARNING : USE SOLVENTS/CLEANING AGENTS, SEALANTS AND OTHER SPECIAL_______
R MATERIALS ONLY WITH A GOOD SUPPLY OF AIR.
R OBEY THE MANUFACTURERS INSTRUCTIONS.
R PUT ON PROTECTIVE CLOTHING.
R DO NOT GET THEM IN YOUR MOUTH.
R DO NOT SMOKE.
R DO NOT BREATHE THE GAS.
R THESE MATERIALS ARE POISONOUS, FLAMMABLE AND SKIN IRRITANT.
R GET MEDICAL HELP IF YOUR SKIN OR EYES BECOME IRRITATED.
R (1) Move the movable fairing, to align the link (5) with the bracket.
R (2) Temporarily install the bolt (8), the washer (13) and the nut (12).
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM WINGS 機翼5(60)
