曝光臺 注意防騙 網(wǎng)曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費(fèi)者

decision has been made, RC goes with the flow. We have to make the best of a bad situation.
RC will put you on the same runway your AI are using, even if that runway is not the most
advantageous/logical runway considering winds.
We have seen it all too often and it is blatantly obvious, AI simply do not always land on
wind-preferred runways. This is unfortunate, a shame really, but putting you on runways that
always point you into the wind guarantees, sooner or later you will come face to face with a
B757 who has landed opposite runway. And of course, your Req Alt Rwy feature is still there
at your disposal.
Downwind
At approximately sixteen miles from the airport you will be turned "downwind", that is
parallel to the runway in the opposite direction of landing. It is always preferred to land into
the wind making your ground speed at touchdown slower, though we have discussed this will
not always happen. Along your downwind leg do not exceed 230 kts.
At larger airports and during busy periods of traffic, it is likely you will have been switched to
a second Approach controller, the “Final” controller. Final handles all sequencing from this
point on and will switch you to Tower at the appropriate time.
Radar Contact ATC Basics
Version 4 December 2, 2007
Copyright JDT LLC 2005 Page 55
Short Final
Approach turns you to downwind. “Ugh. Do I really have to get so far out from the airport?”
You can ask Approach for a Short Final, an early turn onto base/final anytime while on their
downwind legs. Short final is available on the Menu Display page 2. Approach will
accommodate this request according to traffic load.
Get out your geometry books. You are on downwind with 12 miles showing in your DME
and you have already passed the airport. You make the Short Final request and it is approved.
You are turned 90° to base heading directly perpendicular to the localizer. Your DME shows
you getting closer and closer to the field.
You should not expect to intercept the localizer at 12 miles out, but in this case maybe 8 miles
or even closer. This is a learned tool, to be sure. It is very easy, very tempting to make this
request too early; early enough that overshooting the localizer is almost guaranteed.
Remember, the localizer is a "cone", very narrow at the runway expanding as you get further
from the threshold.
Several tips for optimum use:
 Practice. Get used to it and your abilities as a pilot. RC‟s Save/Load feature comes in
handy here.
 Wait until your glide slope needle is at or above the Center of your NAV 1.
 While on base before you are turned onto the localizer, slow the aircraft 10-15kts
slower than you normally would.
In time you will make this request with confidence, especially if you fly the same type aircraft
a lot. Making requests too early will become a thing of the past and you will be intercepting
the localizer well inside the default vectors. But wait. Do not forget. You are not the only
one out there.
Base
The initial approach into the airport area is described above. Eventually you will be turned
“base” approximately sixteen miles out. The Base Leg is a ninety degree left/right turn from
downwind. We are setting you up for “final”. Do not exceed 210 kts on base.
Intercept
At the appropriate time you will be turned further left/right off base to get you started towards
your final approach heading. At all times watch your assigned altitudes. You should be well
into the checklists by now.
Final Approach
The final approach clearance is critical because it sets you up for a smooth entrance to a clean
approach. Listen carefully; it goes by fast. Expect this sequence of words and instructions:
„(your call sign), (your position), (a heading to intercept the localizer/final approach course),
(the FAP, or the Final Approach Altitude), (cleared for approach)‟.
Radar Contact ATC Basics
Version 4 December 2, 2007
Copyright JDT LLC 2005 Page 56
For example: American four twenty one, one zero miles from the marker, fly heading one two
zero, maintain three thousand two hundred until established on the localizer, cleared ILS
runway 09R approach.
The Final Controller is not done with you until you are switched to Tower.
IAP Approaches
IAP Approaches allow you to execute a full approach per your plates, whether the airport is
served by an Approach controller or not.
Watch for the IAP Approach menu item, available as early as 60 miles from the arrival airport
(if that airport is not served by an Approach controller), or as early as initial contact to
Approach if it is.
　
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：航空資料15(89)