EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
32-12-00
ALL ú ú 01 Page 3 ú Jun 10/88
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL
Wing Gear Shock Strut Door
Figure 3
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
32-12-00
ALL ú ú 01 Page 4 ú Jun 10/88
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 FAULT ISOLATION/MAINT MANUAL
WING GEAR DOORS
COMPONENT 102 FIG. SHT QTY ACCESS/AREA REFERENCE
BOARD - WHEEL WELL STRIKE DOOR - SHOCK STRUT INBOARD DOOR - SHOCK STRUT OUTBOARD DOOR - WHEEL WELL INBOARD DOOR - WHEEL WELL OUTBOARD FAIRING - SHOCK STRUT DOOR 2 2 2 2 2 2 2 2 2 2 2 2 WING GEAR WHEEL WELL DOORS WING GEAR DOORS WING GEAR DOORS WING GEAR DOORS WING GEAR DOORS WING GEAR SHOCK STRUT DOORS 32-12-03 32-12-06 32-12-07 32-12-02 32-12-01
Wing Gear Doors - Component Index
Figure 101
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
32-12-00
ALL ú ú 01 Page 101 ú Oct 10/88
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
FAULT ISOLATION/MAINT MANUAL
WING GEAR DOORS
Wing Gear Doors - Component Location
Figure 102 (Sheet 1)
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
32-12-00
ALL ú ú 01 Page 102 ú Oct 10/88
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
FAULT ISOLATION/MAINT MANUAL
RADIUS ROD (REF)
WING GEAR STRIKE BOARD WHEEL WELL INBOARD DOOR
WING GEAR WHEEL
FWD
WELL OUTBOARD DOOR
WING GEAR WHEEL WELL DOORS
B
DOOR (REF) LINKAGE RODS
WING GEAR SHOCK STRUT OUTBOARD DOOR
WING GEAR SHOCK STRUT INBOARD DOOR
WING GEAR SHOCK STRUT DOOR FAIRING
FWD
WING GEAR SHOCK STRUT DOORS C
Wing Gear Doors - Component Location Figure 102 (Sheet 2)
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
32-12-00
ALL ú ú 01 Page 103 ú Oct 10/88
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
WING GEAR DOORS - ADJUSTMENT/TEST
_________________________________
1. General_______
A. This procedure has two tasks:
(1)
The adjustment of the doors for the wing landing gear.
(2)
The adjustment of the doors for the wing landing gear after the door actuator replacement.
B.
When you replace the door, you must adjust the door.
C.
When you replace the sequence valve, it is necessary to operate the door to examine the rigging pin installation. If you can not install the rigging pin freely, the door adjustment is necessary.
D.
When you remove or replace the door actuator, you must adjust the doors. This will make sure that the door actuator is fully locked when the doors are closed. There is a adjustment task for the door actuator replacement.
E.
There is no operational test with these adjustment procedures. Each adjustment procedure is a satisfactory replacement for an operational test.
TASK 32-12-00-835-001
2. Adjustment - Wing Gear Doors____________________________
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 起落架 LANDING GEAR 2(74)
