Panel 191CT (192CT) Figure 404/TASK 53-35-11-991-010
R  EFF : CES  ALL  53-35-11 Page 413 May 01/04 

 Panel 191DT (192DT) Figure 405/TASK 53-35-11-991-011- 12 (SHEET 1)
R  EFF : CES  ALL  53-35-11 Page 414 May 01/04 

 Panel 191DT (192DT) Figure 405/TASK 53-35-11-991-011- 22 (SHEET 2)
R  EFF : CES  ALL  53-35-11 Page 415 May 01/04 

 Panel 191ET (192ET) Figure 406/TASK 53-35-11-991-012
R  EFF : CES  ALL  53-35-11 Page 416 May 01/04 

R R  Panel 193AT (194AT) Figure 407/TASK 53-35-11-991-013 
R  EFF :  301-399,  53-35-11 Page 417 May 01/04
 CES 

R  Panels 147CB and 148DB Figure 408/TASK 53-35-11-991-014
 EFF :  ALL  53-35-11 Page 418 May 01/04
 CES 

R  Panel 191LB (192LB) Figure 409/TASK 53-35-11-991-015
 EFF :  ALL  53-35-11 Page 419 May 01/04
 CES 

R  Wing-to-Fuselage Fairings - Wing Seal Profile Installation Figure 410/TASK 53-35-11-991-004 
R  EFF :  ALL  53-35-11 Page 420 May 01/04
 CES 

 Root Fillet Fairing Figure 411/TASK 53-35-11-991-017
R  EFF : CES  ALL  53-35-11 Page 421 May 01/05 

 **ON A/C 301-399,
 Subtask 53-35-11-020-050-A 
R  A. Removal of the Root Fillet Fairing of the Fairing Panel 191BT (192BT) 
R  (Ref. Fig. 411/TASK 53-35-11-991-017) 
R  (1) Extend the slats (Ref. TASK 27-80-00-866-004). 
R  (2) Remove the sealing compound from the plugs (4). 
R  (3) Remove the plugs (4) from the root fillet fairing (1). 
R  (4) Hold the root fillet fairing (1) and remove the screws (3) and ( 5) 
R  and the washers (2). 
R  (5) Remove the root fillet fairing (1). 
R
 **ON A/C ALL
 Subtask 53-35-11-020-051 
R  B. Remove the Wing-to-Fuselage Fairing Panels 
R 
R  (1) For the fairing panels, 191BT (192BT), 191CT (192CT), 191DT (192DT), 
R  191ET (192ET), 193AT (194AT), 147CB, 148CB, 148DB and 191LB (192LB): 
R  (2) The fairing panels 193AT and 194AT are part of the offwing 
R  escape-slides. Before you remove these fairings you must remove the 
R  offwing escape-slides (Ref. TASK 25-62-42-000-001). 
R  (a) Hold the fairing panel (3) and remove the screws (1) and the 
R  washers (2). 
R  (b) Remove the fairing panel (3). 
R  (3) If you must replace a wing seal profile in the fairing panels 191DT 
R  (192DT), or 191LB (192LB): 
R  (a) Remove the nuts (6), the seal retainer (7), the seal profile (5), 
R  the washers (8) and the screws (9) from the fairing panel (3). 
R

 EFF : ALL
53-35-11Page 422
May 01/05

R **ON A/C 001-001, 051-052,
 Subtask 53-35-11-020-052
 C. Removal of the Access Panel 193BB (194BB) with the Slide Panel (Ref. Fig. 412/TASK 53-35-11-991-019)
 (1)
 Fully extend the flaps (Ref. TASK 27-50-00-866-008).

 (2)
 Remove the screws (2) from the sealing panel (1).

 (3)
 Remove the sealing panel (1).

 (4)
 Remove the screws (4) from the upper side of the access panel (3), which you can see.

 (5)
 Remove the screws (5) from the upper clip assy (7).

 (6)
 Retract the flaps (Ref. TASK 27-50-00-866-009).

 (7)
 Remove the screws (5) from the lower clip assy (6).

 (8)
 Remove the screws (13) from the slide panel (8).

 (9)
 Disconnect the cable assy (12) from the drive trunnion (14) of the inboard flap.

 (10)
 Remove the screws (4) from the lower side of the access panel (3).

 (11)
 Remove the access panel (3) together with the slide panel (8) from the fuselage.

 (12)
 Pull the slide panel (8) out of the access panel (3).

 (13)
 Remove any loose and unwanted sealant in the related area.

 Access Panel 193BB (194BB) Figure 412/TASK 53-35-11-991-019 
R  EFF :  001-001, 051-052,  53-35-11 Page 424 May 01/05
 CES 

 **ON A/C ALL
R  Post SB 27-1117 For A/C 001-001,051-052, Subtask 53-35-11-020-052-A
　
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FUSELAGE 機身2(110)