**ON A/C ALL
3. Job Set-up
__________
Subtask 25-62-44-860-054
A. Aircraft Maintenance Configuration
**ON A/C 001-002,
(Ref. Fig. 402/TASK 25-62-44-991-021) R **ON A/C 003-049, 051-099, 101-149, 151-199, 201-299, 301-399, 401-499,
(Ref. Fig. 402A/TASK 25-62-44-991-021-A)
**ON A/C ALL
(1)
Energize the ground service network
(Ref. TASK 24-42-00-861-001).
(2)
In the cockpit, on the overhead panel 25VU (SIGNS), make sure that the EMER EXIT LT switch (1) is set to the OFF position.
(3)
Make sure that the passenger/crew door (referred to as door) is safetied:
WARNING : BEFORE YOU START WORK ON THE ESCAPE-SLIDE, MAKE SURE THAT
_______ THE DOOR IS SAFETIED. THIS PREVENTS SUDDEN MOVEMENT OF THE DOOR AND ACCIDENTAL DEPLOYMENT OF THE ESCAPE-SLIDE, WHEN YOU OPEN THE DOOR. SUDDEN MOVEMENT OF THE DOOR AND ACCIDENTAL DEPLOYMENT CAN CAUSE INJURY AND/OR DAMAGE.
(a)
Make sure that the door-damper and emergency-operation cylinder is DISARMED (Ref. TASK 52-10-00-860-001).
(b)
Make sure that the emergency control-handle (3) is set to the DISARMED/MANUAL position, with the SAFETY PIN - SLIDE ARMING (98D52103500000) (4) installed.
(4) Make sure that the applicable door is closed (Ref. TASK 52-10-00-410-001).
EFF : ALL
25-62-44Page 417
R Escape-Slide Pack-Assembly Figure 402/TASK 25-62-44-991-021- 13 (SHEET 1)
EFF : 001-002, 25-62-44 Page 418 Aug 01/04
CES
R Escape-Slide Pack-Assembly Figure 402/TASK 25-62-44-991-021- 23 (SHEET 2)
EFF : 001-002, 25-62-44 Page 419 Aug 01/04
CES
R Escape-Slide Pack-Assembly Figure 402/TASK 25-62-44-991-021- 33 (SHEET 3)
EFF : 001-002, 25-62-44 Page 420 Aug 01/04
CES
INTENTIONALLY BLANK
Escape-Slide Raft Pack-Assembly Figure 402A/TASK 25-62-44-991-021-A15 (SHEET 1)
R EFF : 003-049, 051-099, 101-149, 151-199, 201-299, 301-399, 401-499, 25-62-44 Page 422 Aug 01/05
CES
Escape-Slide Raft Pack-Assembly Figure 402A/TASK 25-62-44-991-021-A25 (SHEET 2)
R EFF : 003-049, 051-099, 101-149, 151-199, 201-299, 301-399, 401-499, 25-62-44 Page 423 Aug 01/05
CES
Escape-Slide Raft Pack-Assembly Figure 402A/TASK 25-62-44-991-021-A35 (SHEET 3)
R EFF : 003-049, 051-099, 101-149, 151-199, 201-299, 301-399, 401-499, 25-62-44 Page 424 Aug 01/05
CES
Escape-Slide Raft Pack-Assembly Figure 402A/TASK 25-62-44-991-021-A45 (SHEET 4)
R EFF : 003-049, 051-099, 101-149, 151-199, 201-299, 301-399, 401-499, 25-62-44 Page 425 Aug 01/05
CES
Escape-Slide Raft Pack-Assembly Figure 402A/TASK 25-62-44-991-021-A55 (SHEET 5)
R EFF : 003-049, 051-099, 101-149, 151-199, 201-299, 301-399, 401-499, 25-62-44 Page 426 Aug 01/05
CES
4. Procedure
_________
**ON A/C 001-002,
Subtask 25-62-44-020-075
A. Removal of the Escape-Slide Pack-Assembly (Ref. Fig. 402/TASK 25-62-44-991-021)
(1) Remove the decorative-cover (20) from the pack-assembly (9):
NOTE : There are three different types of decorative-cover (20)
____ attachment:
-
Type 1, burr-strip (Velcro).
-
Type 2, dual-lock re-closable fastener-strip.
-
Type 3, spring loaded latches.
The three different types are not interchangeable.
It is necessary to use more force, to pull apart dual-lock
re-closable fastener-strip, than for burr-strip. You hear a
continual click sound as the two halves are pulled apart.
(a)
Types 1 and 2:
(b)
Type 3: 1 Pull the lower edge of the decorative-cover (20) away from the
1_ Pull the lower edge of the decorative-cover (20) away from the
pack-assembly (9), to disengage the spring clips.
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM EQUIPMENT/FURNISHINGS 設備4(114)
