**ON A/C ALL
4. Procedure
_________
**ON A/C 001-049, 051-061, 101-105, 201-202,
Subtask 25-55-41-020-050
A. Removal of the Tie-Down and Net Attachment Fittings from the Floor Area of the AFT Cargo-Compartment (Ref. Fig. 401/TASK 25-55-41-991-001)
(1)
Remove the cargo net(s) (5), if installed:
(a)
Disconnect the net fittings (6) from the applicable net attachment fittings of the cargo-compartment floor and ceiling areas.
(b)
Remove the cargo net(s) (5).
(2)
Remove the tie-down points (2): NOTE : The removal procedure for all the tie-down points (2) is the
____ same. Therefore, the removal procedure for one tie-down point
(2) only is given here.
(a) Remove the nuts (4), and remove the screws (1) from the tie-down point (2).
EFF : ALL
25-55-41Page 404
(b) Remove the tie-down point (2) from the structure (3).
(3) Remove the tie-down points (8): NOTE : The removal procedure for all the tie-down points (8) is the
____ same. Therefore, the removal procedure for one tie-down point
(8) only is given here.
(a)
Remove the nuts (10), and remove the screws (7) from the tie-down point (8).
(b)
Remove the tie-down point (8) from the plug housing (9).
(c)
If necessary, remove the plug housing (9) from the structure (3).
(4) Remove the seat-track sections (12): NOTE : The removal procedure for all the seat-track sections (12) is
____ the same. Therefore, the removal procedure for one seat-track section (12) only is given here.
(a)
Remove the nuts (13), and remove the screws (11) from the
seat-track section (12).
(b)
Remove the seat-track section (12) from the structure (3).
(5) Remove the tie-down fittings (15): NOTE : The removal procedure for all the tie-down fittings (15) is
____ the same. Therefore, the removal procedure for one tie-down fitting (15) only is given here.
(a)
Remove the nuts (16), and remove the screws (14) from the
tie-down fitting (15).
(b)
Remove the tie-down fitting (15) from the structure (3).
(6) Remove the tie-down fittings (18): NOTE : The removal procedure for all the tie-down fittings (18) is
____ the same. Therefore, the removal procedure for one tie-down fitting (18) only is given here.
(a)
Remove the nuts (19), and remove the screws (17) from the
tie-down fitting (18).
(b)
Remove the tie-down fitting (18) from the structure (3).
EFF : 001-049, 051-061, 101-105, 201-202, 25-55-41Page 405
Aug 01/05
R
CES
Tie-Down and Net Attachment Fittings - AFT Cargo-Compartment Floor Area Figure 401/TASK 25-55-41-991-001- 12 (SHEET 1)
R EFF : 001-049, 051-099, 101-149, 201-299, 25-55-41Page 406 May 01/05
CES
Tie-Down and Net Attachment Fittings - AFT Cargo-Compartment Floor Area Figure 401/TASK 25-55-41-991-001- 22 (SHEET 2)
R EFF : 001-049, 051-099, 101-149, 201-299, 25-55-41Page 407 May 01/05
CES
(7)
Remove the tie-down fitting (21):
(a)
Remove the nuts (22), and remove the screws (20) from the tie-down fitting (21).
(b)
Remove the tie-down fitting (21) from the structure (3).
(8)
Remove the tie-down fittings (24): NOTE : The removal procedure for all the tie-down fittings (24) is
____ the same. Therefore, the removal procedure for one tie-down fitting (24) only is given here.
(a)
Remove the nuts (25), and remove the screws (23) from the tie-down fitting (24).
(b)
Remove the tie-down fitting (24) from the structure (3).
(9) Remove the tie-down fitting (27):
(a)
Remove the nuts (28), and remove the screws (26) from the tie-down fitting (27).
(b)
Remove the tie-down fitting (27) from the structure (3).
(10) Remove the tie-down fitting (30):
(a) Remove the nuts (31), and remove the screws (29) from the tie-down fitting (30).
(b) Remove the tie-down fitting (30) from the structure (3). R **ON A/C 062-099, 106-149, 151-199, 203-299, 401-499,
Subtask 25-55-41-020-050-A
A. Removal of the Tie-Down and Net Attachment Fittings from the Floor Area of the AFT Cargo-Compartment
**ON A/C 062-099, 106-149, 203-299,
(Ref. Fig. 401/TASK 25-55-41-991-001)
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM EQUIPMENT/FURNISHINGS 設備4(42)
