(2)
Apply STORAGE PRESERVATION (Material No. 15-005) or STORAGE PRESERVATION (Material No. 15-006) to all the components of the locking units and to the adjacent cargo
(3)
Install the access panel 826AR on the cargo door.
(4)
Remove the actuator safety locks and close the AFT cargo door (Ref. TASK 52-30-00-860-002).
(5)
Remove the access platform(s).
1EFF : 001-049, 053-099, 101-149, 151-199, 1 52-32-21Page C422 1201-299, 301-399, 401-499, 1Aug 01/05 1 1 1CES 1 1EFF : ALL 1 52-32-22Page 401 1 1 May 01/05 1 1 1CES 1
DOOR - VENT - REMOVAL/INSTALLATION__________________________________
TASK 52-32-22-000-001
Removal of the Vent Door
1. Reason for the Job__________________
Self Explanatory
2. Job Set-up Information______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific No specific circuit breaker(s) safety clip(s)access platform 3.5 m (11 ft. 6 in.)
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
52-30-00-860-001 52-32-13-000-001 Open the FWD or AFT Cargo-Compartment Door with the Yellow Electric PumpRemoval of the Lining and Insulation
R **ON A/C 001-049, 053-099, 101-105, 201-220,
52-32-22-991-001 Fig. 401
R **ON A/C 051-052,
R 52-32-22-991-001-C Fig. 401A
R **ON A/C 106-149, 221-299, 301-399,
52-32-22-991-001-B Fig. 401B
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
**ON A/C 151-199,
52-32-22-991-001-A Fig. 401C
R **ON A/C 401-499,
R 52-32-22-991-001-D Fig. 401D
**ON A/C ALL
3. Job Set-up
__________
Subtask 52-32-22-010-050
A. Get Access
(1)
Open the AFT cargo-compartment door (referred to as cargo door) and safety it with the actuator safety locks (Ref. TASK 52-30-00-860-001).
(2)
Put the access platform in position below the opened cargo door.
(3)
Remove the lining and insulation from the inner side of the cargo door to get access to the vent door mechanism (Ref. TASK 52-32-13-000-001).
Subtask 52-32-22-865-050
B. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------121VU HYDRAULIC/HYD POWER/Y 3803GX N30 122VU DOORS/CARGO 1MJ T12 123VU Y HYD/ELEC/PUMP 3802GX AB06 123VU Y HYD/ELEC/ELEC PUMP/NORM 3801GX AB03
1EFF : ALL 1 52-32-22Page 402 1 1 Aug 01/05 1 1 1CES 1
4. Procedure
_________
**ON A/C 001-049, 053-099, 101-105, 201-220,
(Ref. Fig. 401/TASK 52-32-22-991-001)
**ON A/C 051-052,
(Ref. Fig. 401A/TASK 52-32-22-991-001-C)
**ON A/C 106-149, 221-299, 301-399,
(Ref. Fig. 401B/TASK 52-32-22-991-001-B)
**ON A/C 151-199,
(Ref. Fig. 401C/TASK 52-32-22-991-001-A) R **ON A/C 401-499,
R (Ref. Fig. 401D/TASK 52-32-22-991-001-D) **ON A/C 001-049, 053-099, 101-105, 151-199, 201-220,
Subtask 52-32-22-020-050
A. Removal of the Vent Door
(1)
Remove the nuts (21), the washers (19) and the bolts (18) and disconnect the cover (20) from the brackets of the cargo door.
(2)
Remove the connection rod (13) from the vent door (10) as follows:
(a)
Remove and discard the cotter pin (17) from the nut (16).
(b)
Remove the nut (16), the washers (15),(12), the bush (14) and the bolt (11) from the actuator arm.
(c)
Disconnect the connection rod (13) from the actuator arm.
(3)
Remove and discard the cotter pins (1) from the nuts (2).
R 1EFF : ALL 1 52-32-22Page 403 1 1 Aug 01/05 1 1 1CES 1
Vent Door
Figure 401/TASK 52-32-22-991-001
R 1EFF : 001-049, 053-099, 101-105, 201-220, 1 52-32-22Page 404 1 1 Aug 01/05 1 1 1CES 1
R Vent Door
R Figure 401A/TASK 52-32-22-991-001-C
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM DOORS 艙門6(10)
