EFF : ALL
53-51-00Page 643
Feb 01/99
External Fin to Fuselage Attachment Fittings
Figure 611/TASK 53-51-00-991-006
EFF : ALL 53-51-00 Page 644
Feb 01/98
CES
5. Close-up
________ Subtask 53-51-00-916-060
A. Apply STORAGE PRESERVATION (Material No. 15-005) to the inspection area, if you have removed the surface protection (Ref. TASK 51-75-13-916-001).
Subtask 53-51-00-410-058
B. Close Access
(1)
Make sure that the work area is clean and clear of tool(s) and other items.
(2)
Install the fairings 323AL, 323AR (Ref. TASK 53-55-11-400-001).
(3)
Remove the ground support and maintenance equipment, the special and standard tools and all other items.
EFF : ALL
53-51-00Page 645
TASK 53-51-00-210-014
Detailed Visual Inspection of Rear Pressure Bulkhead AFT Face, Reinforcement Splice at Forward Fin Attachment Area
1. Reason for the Job
__________________
Refer to the MPD TASK: 535105-01
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION
-------------------------------------------------------------------------------
No specific lint-free cloth
No specific access platform 3 m (9 ft. 10 in.)
B. Consumable Materials
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
Material No. 11-004 USA MIL-T-81533 1.1.1TRICHLOROETHANE (METHYL CHLOROFORM) (Ref. 20-31-00)
Material No. 15-005 AIB TN 10138 TYPE I GRADE 2 CORROSION PREVENTIVE TEMPORARY PROTECTIVE COMPOUND (Ref. 20-31-00)
Material No. 15-006 AIB TN 10138 TYPE I GRADE 3 CORROSION PREVENTIVE TEMPORARY PROTECTIVE COMPOUND (Ref. 20-31-00)
C. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
51-75-13-916-001 Repair to a layer of Moisture-Removing Oil ASRM 535116000 (for corrective action) 53-51-00-991-013 Fig. 612
EFF : ALL
53-51-00Page 646
3. Job Set-up__________
Subtask 53-51-00-010-068
A. Get Access
R WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION_______
R BEFORE YOU START A TASK ON OR NEAR:
R - THE FLIGHT CONTROLS
R - THE FLIGHT CONTROL SURFACES
R - THE LANDING GEAR AND THE RELATED DOORS
R - COMPONENTS THAT MOVE.
R WARNING : OBEY THE MANUFACTURER'S INSTRUCTIONS WHEN YOU USE THE SPECIAL_______
R MATERIAL.
R THIS MATERIAL IS DANGEROUS.
R WARNING : USE SOLVENTS/CLEANING AGENTS, SEALANTS AND OTHER SPECIAL_______
R MATERIALS ONLY WITH A GOOD SUPPLY OF AIR.
R OBEY THE MANUFACTURERS INSTRUCTIONS.
R PUT ON PROTECTIVE CLOTHING.
R DO NOT GET THEM IN YOUR MOUTH.
R DO NOT SMOKE.
R DO NOT BREATHE THE GAS.
R THESE MATERIALS ARE POISONOUS, FLAMMABLE AND SKIN IRRITANT.
R GET MEDICAL HELP IF YOUR SKIN OR EYES BECOME IRRITATED.
(1) Put the access platform in position below the access door 312AR.
R
(2) Open the access door 312AR.
(3) Get access to the inspection area.
(4) Carefully clean the inspection area with CLEANING AGENTS (Material
No. 11-004) and a lint-free cloth.
R
