-COMPONENTS THAT MOVE. WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROLS ARE CLEAR.
_______ MOVEMENT OF FLIGHT CONTROLS CAN CAUSE INJURY TO PERSONS AND/OR DAMAGE.
WARNING : WEAR AND ATTACH A SAFETY HARNESS WHEN YOU WORK ON HIGH SECTIONS. A
_______ FALL CAN INJURE OR KILL YOU.
1.
Reason for the Job
__________________
Refer to the MPD TASK: 534105-01
2.
Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific warning notice
No specific 1 ACCESS PLATFORM 1M (3 FT)
EFF : ALL 53-41-00Page A689
Nov 01/04
R
CES
B. Consumable Materials
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
Material No. 11-004 USA MIL-T-81533
1.1.1TRICHLOROETHANE (METHYL CHLOROFORM)
(Ref. 20-31-00) Material No. 19-003 USA AMS 3819
LINT-FREE COTTON CLOTH (Ref. 20-31-00)
C. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
ASRM 53-41-11-101 (for corrective action) ASRM 53-41-11-201 (for corrective action) 53-41-00-991-053 Fig. 641 53-41-00-991-071 Fig. 642 53-41-00-991-072 Fig. 643
3. Job Set-up
__________
Subtask 53-41-00-941-070
A. Install the ground support equipment.
(1)
Put a warning notice in position to tell persons not to operate the flight controls.
(2)
Put the ACCESS PLATFORM 1M (3 FT) in the required position.
Subtask 53-41-00-110-092
B. Cleaning Procedure
WARNING : OBEY THE MANUFACTURER'S INSTRUCTIONS WHEN YOU USE THIS/THESE
_______ MATERIAL/S. USE PROTECTIVE CLOTHING, RUBBER GLOVES, GOGGLES AND A MASK.
EFF : ALL 53-41-00Page A690
Nov 01/04
R
CES WARNING : MAKE SURE THAT THERE IS A GOOD FLOW OF AIR THROUGH THE WORK
_______ AREA WHEN YOU USE SPECIAL MATERIALS. IF YOU GET ONE OF THESE MATERIALS ON YOUR SKIN, IN YOUR MOUTH OR IN YOUR EYES : -FLUSH IT AWAY WITH A FLOW OF CLEAN WATER FOR BETWEEN 10 AND 15 MINUTES. -GET IMMEDIATE MEDICAL AID IF IRRITATION OCCURS. DO NOT BREATHE THE FUMES FROM THE MATERIAL. DO NOT SMOKE WHEN YOU USE THE MATERIAL. DO NOT USE THE MATERIAL NEAR A FLAME, SPARKS OR SOURCES OF HEAT. THESE MATERIALS ARE DANGEROUS : THEY ARE POISONOUS, FLAMMABLE AND SKIN IRRITANTS.
(1) Clean the area with a lint-free cotton cloth MISCELLANEOUS (Material No. 19-003) and the CLEANING AGENTS (Material No. 11-004), and let the area dry.
4. Procedure
_________
(Ref. Fig. 641/TASK 53-41-00-991-053, 642/TASK 53-41-00-991-071, 643/TASK 53-41-00-991-072)
R **ON A/C 001-049, 051-099, 101-149, 201-299,
Subtask 53-41-00-210-111
A. Inspection
(1) Examine the following areas for scratches, dents and cracks:
-
the upper skin of the longitudinal lap joints, including the crack stopper areas at stringer 32 LH between FR 53 and FR 70, external surface.
-
the upper skin of the longitudinal lap joints, including the crack stopper areas at stringer 32 RH between FR 58 and FR 70, external surface.
-
the upper skin of the longitudinal lap joints, including the crack stopper areas at stringer 41 RH between FR 51 and FR 70, external surface.
NOTE : If necessary, refer to the ASRM (Ref. ASRM 53-41-11-101) for
____
the allowable damage limits.
NOTE : If necessary, refer to the ASRM (Ref. ASRM 53-41-11-201) for
____
the correct repair procedure.
Upper Skin of Longitudinal Lap Joints including Crack Stopper Areas, Stringer 32 LH, External Surface Figure 641/TASK 53-41-00-991-053
EFF : ALL 53-41-00Page A692 Nov 01/04 R CES
Upper Skin of Longitudinal Lap Joints including Crack Stopper Areas, Stringer 32 RH, External Surface Figure 642/TASK 53-41-00-991-071
CES
Upper Skin of Longitudinal Lap Joints including Crack Stopper Areas, Stringer 41 LH, External Surface Figure 643/TASK 53-41-00-991-072
EFF : ALL 53-41-00Page A694 Nov 01/04 R CES
R **ON A/C 151-199, 401-499,
Subtask 53-41-00-210-111-A
A. Inspection
(1) Examine the following areas for scratches, dents and cracks:
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FUSELAGE 機身3(32)
